Search

ISO/IEC 24789-2:2011 specifies methods of evaluation for ID‑1 identification card service life in the applications referred to in ISO/IEC 24789-1. It contains no additional or changed requirements for the ID‑1 card properties defined in other applicable standards.

ISO 7752-2:2011 establishes the arrangement, requirements and direction of movement of the basic controls for slewing, load hoisting and lowering, and boom luffing and telescoping, on mobile cranes as defined in ISO 4306-2. It deals with bi-directional controls and the basic arrangement and requirements for cross-shift levers (multi-directional controls). It is intended to be used in conjunction…

ISO/IEC/IEEE 15289:2011 provides requirements for identifying and planning the specific information items (information products, documentation) to be developed and revised during systems and software life cycles and service processes. It specifies the purpose and content of all identified systems and software data records and life cycle information items, as well as records and information items…

ISO/IEC/IEEE 15289:2011 provides requirements for identifying and planning the specific information items (information products, documentation) to be developed and revised during systems and software life cycles and service processes. It specifies the purpose and content of all identified systems and software data records and life cycle information items, as well as records and information items…

B64.0-11 - Definitions, general requirements, and test methods for vacuum breakers and backflow preventers 1 Scope 1.1 The CSA B64 Series covers vacuum breakers and backflow preventers that are used in potable water supply systems to prevent cross-connections. 1.2 This Standard specifies definitions, general requirements, test methods, markings, and instructions that are common to…

B64.10-11 - Selection and installation of backflow preventers 1 Scope 1.1 Application This Standard specifies requirements for the selection and installation of backflow preventers. Additional information on how backflow due to back siphonage and back pressure occurs, and how to select and apply specific devices, is included in Annexes A, B, and C. 1.2 Exclusions 1.2.1 This Standard does not…

1 Scope 1.1 General This Standard applies to electric hot tubs/spas that are factory-built, self-contained packaged units supplied with equipment for heating and circulating water. These units are connected to an electrical supply circuit of 250 V or less (i.e., 125 V maximum to ground). This Standard specifies test procedures, test conditions, and performance requirements for standby…

1 Scope 1.1 General This fenestration Standard/Specification applies to both operating and fixed, new construction and replacement windows, doors, SSPs, TDDs, roof windows, and unit skylights installed into exterior building envelopes. This fenestration Standard/Specification establishes material-neutral, minimum, and optional performance requirements for windows, doors, SSPs, TDDs, roof…

1 Scope 1.1 This Standard describes the design, construction, load rating, installation, erection, inspection, maintenance, repair, modification, test, and operation of lattice and telescopic boom mobile cranes. Note: See Annex A for illustrations of mobile cranes and Annex B for illustrations of parts of a mobile crane. 1.2 This Standard applies only to machines that have all of the following…

1 Scope 1.1 This Standard specifies design and performance requirements, test methods, and requirements for marking and labelling individual connecting components used as part of a personal fall arrest system (PFAS). This Standard applies to components that are (a) used in the interconnection of a complete PFAS unit in accordance with CSA Z259.10; (b) intended to be used as the primary single…