Search

ISO/IEC TR 29144:2014 discusses concepts and considerations for the use of biometrics in a commercial Identity Management Solution, items that need to be considered when integrating biometrics into a commercial Identity Management Solution, and implementation issues when implementing biometrics into commercial Identity Management Solutions. ISO/IEC TR 29144:2014 does not define an architecture…

Scope 1.1 This Standard specifies test procedures to determine the performance of general service directional lamps. Note: This Standard is intended to be technology neutral. 1.2 This Standard does not include requirements for luminaires used with general service lamps and for coloured directional lamps. Notes: 1) For the purpose of this Standard, general service lamps refer to…

Scope 1.1 This Standard defines minimum energy efficiency and performance requirements for light emitting diode (LED) lamps with an ANSI or IEC standardized base that are designed to connect to a low-voltage or branch circuit via a lampholder. The criteria in this Standard apply to both integral LED lamps of nonstandard form, and to those intended to replace standard general service…

1.1 This Standard applies to indoor and outdoor meter-mounting devices, either as complete self-contained devices or provided as a part of service equipment, for use in nonhazardous locations, and intended to be employed in accordance with the Rules of the Canadian Electrical Code, Part I (“CEC Part I”). 1.2 This Standard covers devices for use with watt hour meters, demand meters, time…

1.1 This Standard applies to electric motors and generators for installation and use, in accordance with the Rules of the Canadian Electrical Code, Part I, in non-hazardous locations. Note: The term “machine” throughout this Standard should be assumed to mean “motor” and “generator”. 1.2 Clauses 2 to 7 are general in nature and apply, unless otherwise noted, to the motors and generators…

1.1 This Standard applies to electrically-powered door opening devices and other opening and closing appliances rated at 600 V or less and intended to be used in nonhazardous locations in accordance with the Rules of the Canadian Electrical Code, Part I. 1.2 This Standard gives requirements for complete doors, gates, and other such assemblies that include electrically-powered opening and…

1.1 This Standard applies to single- and multiple-conductor fire alarm and signal cables with a maximum nominal voltage rating of 300 V and a minimum temperature rating of 60 °C for use in buildings and other structures in dry or damp locations in accordance with the Rules of Sections 16 and 32 of the Canadian Electrical Code, Part I. 1.2 Because other CSA Group Standards specify…

1 Scope 1.1 This Standard applies to concrete block masonry units made from cementitious materials, water, and aggregates, with or without the inclusion of other materials. This Standard may be applied to other units of similar manufacture and size within the limitations of the Standard. Note: For concrete brick masonry units, see CSA A165.2. For prefaced concrete masonry units, see CSA A165…

1.1 This Standard describes the requirements for the design and installation of a fire alarm system with or without voice communication capability, as defined in Section 3, Glossary. NOTE 1: This Standard is intended to apply to both required and voluntary fire alarm installations. NOTE 2: The requirements in this Standard address the installation for various types of fire alarm system…

12614-16:2014 specifies tests and requirements for the heat exchanger - vaporizer, a liquefied natural gas fuel system component intended for use on the types of motor vehicles defined in ISO 3833. ISO 12614-16:2014 is not applicable to the following: a) fuel containers; b) stationary gas engines; c) container mounting hardware; d) electronic fuel management; e) refuelling…