Mechanical couplings for drain, waste,and vent pipe and sewer pipe
1.1
This Standard covers mechanical couplings that are used to axially join pipes and fittings in non-pressure
drain, waste, and vent (DWV) piping systems and sewer piping systems located inside or outside
buildings and above ground or underground.
Notes:
1) Caution should be exercised when installing mechanical couplings and elastomeric end caps at low
temperatures. The coupling or…
1 Scope
This Standard provides rules and requirements for the design, fabrication, erection, inspection, testing,
maintenance, and use of falsework and formwork materials, components, and systems where they are
erected to provide temporary vertical and lateral support or containment of freshly placed concrete for
buildings and other structures during their construction, alteration, or repair…
1.1
This Standard specifies requirements for sustainable forest management (SFM) of a defined forest area
(DFA), including requirements for
a) the management framework;
b) commitment;
c) public participation;
d) performance measures and targets;
e) the systematic review of actions;
f) the monitoring of effectiveness; and
g) continual improvement.
Note: While this Standard provides…
Asphalt shingles made from glass felt and surfaced with mineral granules
1.1
This Standard covers asphalt roofing shingles composed of impregnated glass felt, coated on both sides
with asphaltic material and surfaced on the weather side with mineral granules. This Standard is
designed for the evaluation of products as they are manufactured or as agreed upon between the
purchaser/user and the manufacturer/supplier.
1.2
This Standard covers shingles that are
a)…
1.1
This Standard specifies requirements related to the performance, design, testing, labelling, and
provision of instructions for manufactured single-span horizontal lifeline systems (HLL systems) (see
Figure 1). These HLL systems are a component of a complete system for fall arrest.
1.2
This Standard does not apply to
a) HLL systems
i) with span lengths greater than 18.3 m (60 ft);
ii)…
Selection and use of active fall-protection equipment and systems
1.1
This Standard specifies requirements for the selection, use, and application of active fall-protection equipment and systems.
1.2
The purpose of this Standard is to provide criteria and considerations for the safe selection and use of active fall-protection equipment and systems.
1.3
The selection and use of fall-protection systems as part of a fall-protection program that may include…
1.1
This Standard applies to newly produced illuminating appliances constructed entirely of new, unused
parts and materials for use with:
a) natural gas;
b) propane; or
c) butane.
1.2
These requirements cover gas-fired lighting appliances intended for either outdoor or indoor installation
for attachment to fixed gas piping systems. Appliances approved for indoor use under this Standard…
This standard applies to compost produced from different feedstocks, used as organic soil
conditioners, sold or distributed in bags or in bulk.
This document was developed to serve as a reference document for the conformity assessment
activities related to specific products.
NOTE — Conformity assessment is defined as the systematic examination of the extent to which a
process fulfils specified…
Printed electronics - Part 201: Materials - Substrates
IEC 62899-201:2016(E) defines the terms and specifies the evaluation method for substrates used in the printing process to form electronic components/devices. This international standard is also applied to the substrates which make surface treatment in order to improve their performance.
Printed electronics - Part 202: Materials - Conductive ink
IEC 62899-202:2016(E) defines the terms and specifies the standard methods for characterisation and evaluation. This International Standard is applicable to conductive inks and conductive layer that are made from conductive inks.
