Search

1 Scope 1.1 General This Standard establishes criteria for emergency preparedness and response for the petroleum and natural gas industry systems. Note: Prevention, continuity, and recovery are addressed in other standards. 1.2 Applicability This Standard applies to petroleum and natural gas industry systems (see Figures 1and 2), including a) pipeline systems handling i) oil; ii) gas…

1 Scope 1.1 Purpose The purpose of this Standard is to provide criteria for the safe erection, use, and inspection of access scaffold (as covered in CSA S269.2 and engineered systems) and for the training of erectors and users of such equipment. 1.2 Subjects addressed This Standard applies to the erection, use, and inspection of access scaffold, and to training requirements for access…

Scope This National Standard specifies minimum requirements for preparing, developing, and conducting challenge-based, agile and open procurement of digital products and services. This Standard defines a framework for organizations evaluating the suitability of digital product and service providers using “challenge-based” criteria. This methodology requires organizations sourcing digital,…

1 Scope 1.1 General This Standard addresses the following aspects of cementitious materials: a) their definitions; b) their chemical, physical, and uniformity requirements; c) the tests required; d) the procedures for inspection and sampling; and e) the units of measurement, packaging, marking, and storage. 1.2 Classifications The cementitious materials for use in concrete are…

This document: —     defines requirements for vacuum insulation panels (VIPs) with silica or glass fibre core, which are used for thermal insulation of buildings; —     outlines required product properties, their performance, test methods and rules for conformity evaluations, identification and labelling; —     provides a test method to determine ageing factors and the influence of the linear…

This document specifies an acceptance sampling system of single sampling plans for inspection by variables, primarily designed for use under the following conditions: a)       where the inspection procedure is applied to an isolated lot of discrete products all supplied by one producer using one production process; b)       where only a single quality characteristic, x, of this process is taken…

This document specifies principles, requirements and guidance for achieving and demonstrating carbon neutrality through the quantification, reduction and offsetting of the carbon footprint. This document defines terms used in relation to carbon neutrality and provides guidance on the actions necessary to achieve and demonstrate carbon neutrality. In accordance with common practice, it uses the…

1.1     This document specifies two methods (method A and method B) for the determination of the tensile-impact strength of plastics under defined conditions. The tests can be described as tensile tests at relatively high strain rates. These methods can be used for rigid materials (as defined in ISO 472), but are especially useful for materials too flexible or too thin to be tested with impact…

ISO 14044 requires the goal and scope of an LCA to be clearly defined and be consistent with the intended application. Due to the iterative nature of LCA, it is possible that the LCA scope needs to be refined during the study. This document specifies methodologies that can be applied to determine the carbon footprint of a product (CFP) or partial CFP of a hydrogen product in line with ISO 14067.…

This standard specifies the characteristics of biomethane at the injection point in the natural gas distribution or transmission system to ensure its compatibility with the characteristics of the natural gas present in the system into which it is injected. It applies to biomethane produced from biogas derived from anaerobic decomposition, no matter the source of the organic material. NOTE —…