Search

1 Scope This document specifies the concepts, framework, test methods, and criteria required to test conformity of biometric products claiming conformance to BioAPI (see ISO/IEC 19784-1). Guidelines for specifying BioAPI conformance test suites, writing test assertions, and defining procedures to be followed during the conformance testing are provided. This document is concerned with…

1 Scope 1.1 This Standard sets forth characteristics of effective and durable installation methods, in both new and existing buildings, of fenestration products within the scope of AAMA/WDMA/CSA 101/I.S.2/A440 that are intended for installation in buildings of all occupancies to which NBC Parts 3, 4, 5, and 6 of Division B apply. 1.2 In addition to fenestration products within the scope of…

1 Scope 1.1 This Standard specifies mechanical and electrical requirements for dispensers of compressed hydrogen gas intended for fuel storage systems integral to fuel cell vehicles at pressures of 25, 35, 50, and 70 MPa. Dispensing systems covered by this Standard include a) HGV dispensers that integrate all dispensing system components in a single unit, including fuel metering and…

1 Scope 1.1 This Standard specifies the design, installation, operation, and maintenance of site-built and modular gaseous hydrogen fuelling stations (HFS) intended to fuel on-road vehicles. 1.2 Unless otherwise stated, the standard conditions are as follows: temperature 15 °C and pressure 101 kPa. 1.3 In case of conflict between this Standard and federal, provincial, state, or local…

1 Scope This part of ISO/IEC 19794 specifies a data record interchange format for storing, recording, and transmitting the information from one or more finger or palm image areas. This can be used for the exchange and comparison of finger image data. It defines the content, format, and units of measurement for the exchange of finger image data that may be used for enrolment, verification, or…

This document specifies the requirements and test methods for the dimensional, physical, and mechanical characteristics of the ductile cast iron piping and joints used for both drinking water and sewer piping. It applies to piping with bell-and-spigot joints 75 mm to 1600 mm in diameter and piping with mechanical joints 75 mm to 600 mm in diameter. NOTES — 1 The requirements for the…

This document specifies characteristics for adhesives for floor coverings, which comprise: — resilient floor coverings (such as those manufactured from plastics, linoleum or rubber); — textile floor coverings. Adhesives for floor coverings are intended for use within a building according to the manufacturer's specification. This document specifies requirements for establishing…

1.1 This document gives a general test method for the determination of the temperature of deflection under load (flexural stress under three-point loading) of plastics. Different types of test specimen and different constant loads are defined to suit different types of material. 1.2 ISO 75-2 gives specific requirements for plastics (including filled plastics and fibre-reinforced plastics in…

This document defines a number of specification operators for the specification of extended edge transition features between features. An edge transition feature is an integral feature connecting two adjacent integral features. The extended edge transition feature includes portions of the adjacent features. All these specifications apply to any line in a defined direction in the extended edge…

This document provides an overview of recent research on readability of electrophoretic displays. It also provides information for evaluating readability of electrophoretic displays and defining the context of their use.