Search

IEC 61156-5:2020 describes the cables intended primarily for horizontal floor wiring as defined in ISO/IEC 11801. It covers cable designs comprising individually screened, common screened and unscreened pairs or quads. The transmission characteristics and the frequency range of the cables are specified at 20 °C. The cables covered by this document are intended to operate with voltages and…

This document defines the requirements and operation of the on-board vehicle equipment that enables magnetic field wireless power transfer (MF-WPT) for traction battery charging of electric vehicles. It is intended to be used for passenger cars and light duty vehicles. This document addresses the following aspects for an EV device: — safety requirements; — transferred power and power…

This document describes laser radiation hazards arising in laser processing machines, as defined in 3.7. It also specifies the safety requirements relating to laser radiation hazards, as well as the information to be supplied by the manufacturers of such equipment (in addition to that prescribed by IEC 60825). Requirements dealing with noise as a hazard from laser processing machines are included…

This document describes laser radiation hazards arising in laser processing machines, as defined in 3.7. It also specifies the safety requirements relating to laser radiation hazards, as well as the information to be supplied by the manufacturers of such equipment (in addition to that prescribed by IEC 60825). Requirements dealing with noise as a hazard from laser processing machines are…

1 Scope 1.1 This Standard applies to portable luminaires, intended for use in dry, damp, and wet locations, and intended to be used in accordance with the Rules of CSA C22.1, Canadian Electrical Code, Part I, in non- hazardous locations, on a nominal 120 V system and 15 or 20 A branch circuits, or on the load side of a Class 2, LED Class 2, or safety extra-low voltage (SELV) circuit. 1.2 This…

1 Scope 1.1 1.1.1 The requirements specified in this Standard cover light-emitting diode (LED) equipment that is an integral part of a luminaire or other lighting equipment and that operates in the visible light spectrum between 400 and 700 nm. These requirements also cover the component parts of LED equipment, including LED controlgear, controllers, arrays, modules, and packages, as…

1 Scope 1.1 This Standard covers outdoor and wet location, light-sensitive, photo-electric control units of the plug- in, locking type, rated 600 V, 60 Hz ac or less, that are intended for controlling electric luminaires of the magnetic ballast, electronic ballast, tungsten-filament type, or light-emitting-diode (LED) and their associated driver, and that are intended to be employed for area…

1 Scope 1.1 This Standard covers integral horsepower, three-phase, alternating current, squirrel cage induction motors rated up to 15 kV at 50/60 Hz. This Standard also covers inverter duty motors. 1.2 The values given in SI units are the units of record for the purposes of this Standard. The values given in parentheses are for information and comparison only. 1.3 In this Standard, “shall”…

1 Scope This clause of Part 1 is replaced as follows: 1.1 This standard applies to the evaluation of thermal protectors for ballasts for tubular fluorescent lamps. Requirements concerning the testing of the combination of ballast and thermal protector are given in IEC 920. Requirements concerning the testing of the combination of ballast and thermal protectors are given in CAN/CSA-…

1 Scope 1.1 This Standard specifies tests and requirements for the flexible fuel line or vent line for service temperatures colder than –40 °C (–40 °F) and cryogenic conditions, a liquefied natural gas fuel system component intended for use on the types of motor vehicles defined in ISO 3833. This Standard is not applicable to the following: a) fuel containers; b) stationary gas engines; c…