Intelligent transport systems — Information for emergency service support via personal ITS station —...
This document defines the use cases and general requirements for supporting emergency services via P-ITS-S. Any automotive-related service providers can refer to this document for developing eCall service systems into eCall non-supportive vehicles.
The P-ITS-S acts as a monitoring and data transmitting device which gathers a vehicle's speed, impact and airbag deployment signal to assess the…
Information technology — Automatic identification and data capture techniques — Direct Part Mark (DP...
This document is an engineering document intended for verifier manufacturers and application specification developers.
This document describes modifications to the symbol quality methodology defined in ISO/IEC 15415 and a symbology specification. It defines alternative illumination conditions, some new terms and parameters, modifications to the measurement and subsequent grading of certain…
This document specifies design, construction, installation and test requirements for remote mechanical cable steering systems and the output ram interface point to rudders, jet drives, outboard and sterndrive engines for small craft.
It is applicable to three distinct classes of steering systems for use on various types of craft:
— standard duty steering systems, for small craft with single…
Information technology - Automatic identification and data capture techniques - Direct Part Mark (DP...
This document is an engineering document intended for verifier manufacturers and application specification developers.
This document describes modifications to the symbol quality methodology defined in ISO/IEC 15415 and a symbology specification. It defines alternative illumination conditions, some new terms and parameters, modifications to the measurement and subsequent grading of certain…
Fibre optic interconnecting devices and passive components - Basic test and measurement procedures -...
IEC 61300-3-30:2020 describes a method of measuring the end face geometry of rectangular multifibre ferrules having an IEC defined optical interface. The primary attributes are fibre position relative to the end face, either withdrawal or protrusion, end face angle relative to the guide pin bores, fibre tip radii and core dip for multimode fibres. This second edition cancels and replaces the…
This document specifies requirements for through-hull fittings, seacocks, hose connections, their fittings and their installation in small craft with a length of hull, LH, as defined in ISO 8666:2020, of up to 24 m.
This document is not applicable to engine and heater exhaust fittings, and sail drive through-hull fittings.
Photography — Electronic still picture imaging terminology — Part 1: Supplemental vocabulary
This document defines terms used in electronic still picture imaging that have not been defined by other ISO/TC 42 standards, Technical Specifications or Technical Reports.
1 Scope
1.1 Introduction
1.1.1 Fire fighters (FF) performing operations involving buildings with attached or integrated Photovoltaic
(PV) arrays may be exposed to electrical hazards from damaged PV equipment. These requirements
provide a means for evaluation of PV Hazard Control components, equipment and systems that provide a
reduced level of shock hazard from energized PV system equipment…
Material declaration for products of and for the electrotechnical industry
IEC 62474:2018+A1:2020 specifies the procedure, content, and form relating to material declarations for products of companies operating in and supplying the electrotechnical industry. Process chemicals and emissions during product use are not in the scope of this International Standard. It provides data to downstream manufacturers that:
- allows them to assess products against substance…
Medical electrical equipment - Diagnostics X-rays - Part 1: Determination of quality equivalent filt...
IEC 60522-1:2020 applies to X-RAY TUBE ASSEMBLIES and to FILTERING MATERIAL, in medical diagnostic applications up to a HIGH VOLTAGE of 150 kV. For HIGH VOLTAGES greater than 50 kV, this document applies to X-RAY TUBE ASSEMBLIES with tungsten or tungsten-alloy TARGETS only.
IEC 60522-1:2021 defines the concept of PERMANENT FILTRATION of X-RAY TUBE ASSEMBLIES, and it defines the term FILTERING…