Search

ISO 6673 specifies a method for the determination of the loss in mass at 105 °C of green coffee. It is applicable to decaffeinated and non-decaffeinated green coffee as defined in ISO 3509. This method of determining the loss in mass can be considered, by convention, as a method for determining the water content and can be used as such by agreement between the interested parties, but it gives…

This part of ISO 7206 specifies a test method for determining short-term deformation of a press-fit acetabular component for total hip joint replacement under specific laboratory conditions. It also defines the conditions of testing so that the important parameters that affect the components are taken into account and it describes how the specimen is set up for testing. The described method is…

ISO 17987-4:2016 specifies the 12 V and 24 V electrical physical layers (EPL) of the LIN communications system. The electrical physical layer for LIN is designed for low-cost networks with bit rates up to 20 kbit/s to connect automotive electronic control units (ECUs). The medium that is used is a single wire for each receiver and transmitter with reference to ground. ISO 17987-4:2016 includes…

ISO 17987-2:2016 specifies a transport protocol and network layer services tailored to meet the requirements of LIN‑based vehicle network systems on local interconnect networks. The protocol specifies an unconfirmed communication. The LIN protocol supports the standardized service primitive interface as specified in ISO 14229‑2. ISO 17987-2:2016 provides the transport protocol and network layer…

ISO 17987-7:2016 specifies the conformance test for the electrical physical layer (EPL) of the LIN communications system. It is part of this document to define a test that considers ISO 9646 and ISO 17987‑4. The purpose of ISO 17987-7:2016 is to provide a standardized way to verify whether a LIN bus driver is compliant to ISO 17987?4. The primary motivation is to ensure a level of…

ISO 25178-606:2015 defines the metrological characteristics of a particular non-contact method measuring surface texture using a focus variation (FV) sensor.

ISO 1938-1:2015 specifies the most important metrological and design characteristics of plain limit gauges of linear size. ISO 1938-1:2015 defines the different types of plain limit gauges used to verify linear dimensional specifications associated with linear size. ISO 1938-1:2015 also defines the design characteristics and the metrological characteristics for these limit gauges as well as the…

This document specifies the calibration and adjustment of the metrological characteristics of contact (stylus) instruments for the measurement of surface texture by the profile method as defined in ISO 3274. The calibration and adjustment is intended to be carried out with the aid of measurement standards. Annex B specifies the calibration and adjustment of metrological characteristics of…

This document defines the language of symbols used in the ISO 10360 series of documents to identify metrological characteristics of coordinate measuring systems (CMSs) and their maximum permissible errors (MPEs) or limits (MPLs).

This document specifies the safety requirements for horizontal directional drilling (HDD) machines (hereafter referred to as HDD machines) as defined in ISO 21467:2023 which are designed primarily for drilling through the earth in a mostly horizontal direction. This document is applicable to the following HDD machine types: portable HDD machines; pedestrian-controlled HDD machines; towed HDD…