Building construction — Modular coordination — System of preferred numbers defining multimodular siz...
Establishes a system of preference for numbers for use as the numerical factor in multimodular sizes especially for horizontal dimensions in building, and guidance for its use. Is applicable to buildings of all types designed in accordance with the principles and rules of modular coordination as laid down in ISO 2848.
Lifts and service lifts (USA : elevators and dumbwaiters) — Part 6: Passenger lifts to be installed ...
Lays down the appropriate rules applying to standardized lifts of class I and permitting the number of lifts and their main characteristics to be defined at the very beginning of building design. Three quality levels are specified for the lift service. Part 1 covers the lifts of classes I, II and III, part 2 the lifts of class IV, part 3 service lifts of class V and part 5 control devices,…
Defines terms relating to gas analysis, in English and in French. The vocabulary is restricted to the presentation of the methods most currently used in gas analysis. Alphabetical indexes in english and french languages are also given.
Earth-moving machinery — Operation and maintenance — Training of mechanics
Describes the training of mechanics appropriate for earth-moving machinery. Does not specify any procedure for assessing proficiency or competence, since these factors are usually covered by local and national practices and regulations. Applies to all earth-moving machinery as defined in ISO 6165.
Paints and varnishes — Indentation test (spherical or pyramidal)
The test method is applicable on a single or multi-coat system. The result is expressed as the depth of indentation produced when an indentor of specified or between the interested parties agreed size and shape is applied to the coating under defined conditions. The method is applicable if the identation does not exceed approximately 10 % of the total coating thickness. The indentation apparatus…
Textile fabrics — Burning behaviour — Measurement of flame spread properties of vertically oriented ...
A defined ignition flame from a specified burner is applied to vertically oriented textile specimens for a defined period of time. The flame spread time is that time for a flame to travel between marker threads located at defined distances in seconds. Other properties relating to flame spread may also be observed, measured and recorded.
Asbestos-cement products — Part 3: Asymmetrical section corrugated sheets and fittings for roofing a...
Specifies characteristics of straight asbestos-cement asymmetrical section corrugated sheets and their asbestos-cement fittings to be used mainly for roofing and cladding. It also defines tests to check these products, marking and conditions of acceptance. Same requirements can apply, by agreement between manufacturer and purchaser, to curved asymetrical section corrugated sheets.
Effective Sterilization in Hospitals by the Ethylene Oxide Process
Defines essential elements in a program for using ethylene oxide
to sterilize products in hospitals and similar non-industrial
facilities with the object of achieving an adequate level of
sterility assurance and minimizing the risk of injury to patients
and to the health and safety of hospital staff that is attendant
on the use of this compound.
Round punches with 60 degrees conical head and straight shank
Lays down the basic dimensions of these punches in the diameter range of 0,5 to 15 mm. It gives as examples materials and hardness, and specified designation of punches. The main use of punches as defines in ISO 6752 is for punching holes in steel steet. They may also be used when punching holes in other materials.
Pipework — Stripwound flexible metal hoses — Testing and verification of characteristics
Specifies test methods necessary to check characteristics of hoses as defined in the specific product standards for each hose type. It also specifies complementary tests, the results of which can be essential to purpose users.