Tolerances for building — Presentation of dimensional accuracy data
Lays down the principles on which the collection of dimensional accuracy data in building construction work shall be based and the format in which this data shall be presented for defined items of construction and manufactured components. Is intended for use in all types of building construction.
1. Scope
1.1 This Standard applies to electrostatic air cleaners intended to remove dust and dirt from the air and intended for general indoor residential and commercial use.
1.2 These requirements do not apply to electrostatic air cleaners for use in hazardous locations or in atmospheres defined as hazardous by the Canadian Electrical Code, Part I.
1.3 These requirements do not…
Wheelchairs - Nomenclature, Terms, and Definitions
1. Scope
1.1 This Standard defines the basic elements of manual, electric, and any other types of wheelchairs and gives terms and definitions for these elements. It also illustrates the dimensions most commonly used to describe the physical characteristics of wheelchairs. Note: This Standard is not intended to cover all the terms and definitions used when referring to wheelchairs. It is…
Fasteners — General requirements for bolts, screws, studs and nuts
Requires that standardized products are defined by: mechanical properties (material), product grade (tolerances), surface coatings (if required), special requirements (if agreed); gives specifications and reference to International Standards.
Aerospace — Omega clamps (saddle clamps) for fluid systems — Dimensions
Includes maximum and minimum dimensions for clamps installed by means of two bolts with nominal diameters of 5 mm. The specified dimensions define a dimensional envelope. Shall not be considered as an interchangeability standard. The tolerances for each type of clamp are to be defined in the parts standards drawings. These clamps are intended for the installation, support and guiding of rigid…
Information processing - Data interchange on 130 mm (5.25 in) flexible disk cartridges using modifie...
Defines the quality of recorded signals, the track layout, and a track format (format B) to be used on 130 mm (5.25 in) flexible disk cartridges intended for data interchange between data processing systems. To be used in conformance with ISO 7487 when it meets all requirements of either parts 1 and 2 or parts 1 and 3 of it.
Information processing — Data interchange on 130 mm (5.25 in) flexible disk cartridges using modifie...
Defines the quality of recorded signals, the track layout, and a track format (format B) to be used on 130 mm (5.25 in) flexible disk cartridges intended for data interchange between data processing systems. To be used in conformance with ISO 7487 when it meets all requirements of either parts 1 and 2 or parts 1 and 3 of it.
Defines the basic terms and lays down the technical specifications of temple cylinders. Designates the parts of a temple cylinder by means of an illustration. The dimensions of rings are contained in a table. Specifies the designation of a temple cylinder.
Anodizing of aluminium and its alloys — Vocabulary
ISO 7583 defines terms concerning anodized aluminium. In addition to terms in the three official ISO languages (English, French and Russian), this International Standard gives the equivalent terms and definitions in the German and Italian languages.
Manganese and chromium ores — Experimental methods for evaluation of quality variation and methods f...
Specifies experimental methods for the evaluation of quality variation of manganese and chromium ores, whether natural or processed, for the purpose of defining sampling procedure by the mass-basis systematic method and the two-stage method as specified in the relevant International Standards. It also specifies methods for checking the precision of sampling by the mass-basis systematic method and…
