Search

Defines the grades of cold-rolled non-oriented magnetic steel sheet and strip in nominal thicknesses of 0.35 mm, 0.47 mm, 0.50 mm and 0.65 mm. In particular, it specifies general requirements, the magnetic properties, geometric and technological characteristics, as well as the inspection procedure.

Defines equipment, methods and procedures for obtaining laboratory measurements of airborne sound-pressure levels radiated by control valves and/or associated piping configurations, including fixed restrictions, through which compressible fluids are passing. Provides a method of testing the noise-generating characteristics of control valves. The noise characteristics to be determined are useful…

1. Scope 1.1 This Standard contains the requirements for the quality assurance program applicable to the commissioning phase of a nuclear power plant. 1.2 This Standard embodies the relevant quality assurance requirements of CSA Standard CAN3-N286.0, and is the governing Standard for commissioning quality assurance activities in the event of any conflicting requirements. 1.3…

Lays down the basic dimensions and tolerances in millimetres for theses round punches in the diameter range 1 to 32 mm. Gives matrial and ahrdness as examples, and specifies the designation of punches. The main use of punches defined in ISO 8021 is for punching holes in steel sheet or in sheet of other materials.

1. Scope 1.1 This Standard prescribes a method for determining heat outputs, appliance efficiencies, emission levels and composition, and flue gas flow rates for wood-fired appliances with a closed fire chamber. 1.2 For the purpose of this Standard, a wood-fired appliance with a closed fire chamber is one in which the air-fuel ratio is less than 30:1 by weight during the burning of at…

Specifies the pitches of needles for knitting machines. Defines needle pitch (distance between the centres of two adjacent needles in the same needle carrier, in millimetres) and gauge (number of needle pitches per 25.4 mm). The needle pitch may be used as a basis for assessment of fabrics knitted on these machines.

Specification of the procedure of pipe sample extraction with carbondioxide water in three steps of extraction. The quantities of cadmium and mercury in the water extracts shall be determined, but the analytical methods for these determinations are not defined.

A statement of requirements (SOR) is defined as a document to be provided by a user to specify his requirements to a manufacturer. A model SOR is described to enable a user to define his requirements fully, without ambiguity and in standard form so that the supplier can meet the requirements as accurate as possible. Annex A contains a standard form for a SOR, annex B shows clearances.

Specifies a procedure for approximating a volume of a typical material carried in the bowl of an elevating scraper. The volumes are based on the inside dimensions of the bowl and a representative volume on top of the bowl. The method is intended to provide a consistent means of comparing capacities; it is not intended to define actual capacities that might be observed in any specific application.

Defines zones of comfort and reach for controls derived from the overlapping reach capability of large and small operators in the seated position. Is intended as a guide for the design of the operator compartment controls for earth-moving machinery. Cancels and replaces the first edition (ISO 6682 : 1980), of which it constitutes a minor revision.