Search

This part of ISO 14526 specifies the requirements for the physical and chemical properties of phenolic powder moulding compounds (PF-PMCs) and compression- or injection-moulded test specimens produced from them. It is limited to those powder moulding compounds whose composition and properties are significantly different. It is further limited to those moulding compounds which are of general…

This part of ISO 14527 specifies the requirements for the physical and chemical properties of urea-formaldehyde and urea/melamine-formaldehyde powder moulding compounds (UF- and UF/MF-PMCs) and compression- or injection-moulded test specimens produced from them. It is limited to those powder moulding compounds whose composition and properties are significantly different. It is further limited to…

This part of ISO 14528 specifies the requirements for the physical and chemical properties of melamineformaldehyde powder moulding compounds (MF-PMCs) and compression- or injection-moulded test specimens produced from them. It is limited to those powder moulding compounds whose composition and properties are significantly different. It is further limited to those moulding compounds which are of…

This part of ISO 14529 specifies the requirements for the physical and chemical properties of phenolic powder moulding compounds (MP-PMCs) and compression- or injection-moulded test specimens produced from them. It is limited to those powder moulding compounds whose composition and properties are significantly different. It is further limited to those moulding compounds which are of general…

This part of ISO 14530 specifies the requirements for the physical and chemical properties of unsaturated-polyester powder moulding compounds (UP-PMCs) and compression- or injection-moulded test specimens produced from them. It is limited to those powder moulding compounds whose composition and properties are significantly different. It is further limited to those moulding compounds which are of…

This International Standard specifies the required characteristics for metric self-locking nuts, with MJ threads, for use in aerospace construction at a maximum temperature less than or equal to 425 °C. It is applicable to nuts as defined above, provided that reference is made to this International Standard in the relevant definition document.

This part of ISO 15252 specifies the requirements for the physical and chemical properties of epoxy powder moulding compounds (EP-PMCs) and compression- or injection-moulded test specimens produced from them. It is limited to those powder moulding compounds whose composition and properties are significantly different. It is further limited to those moulding compounds which are of general…

IEC 60193:1999 applies to laboratory models of any type of impulse or reaction hydraulic turbine, storage pump or pump-turbine. This standard applies to models of prototype machines either with unit power greater than 5 MW or with reference diameter greater than 3 m. Full application of the procedures herein prescribed is not generally justified for machines with smaller power and size.…

This National Standard of Canada is based on International Standard CEI/IEC 1264:1994. 1 General 1.1 Scope This standard applies to hollow insulators made of ceramic metarial, with their fixing devices, intended for use with a permanent gas pressure greater than 0,5 bar having an internal volume equal to or greater than 1 litre (1 000 cm³). They are intended for use in electrical…

Specifies requirements for the construction and testing of caplights for use in mines susceptible to firedamp (Group I - electrical apparatus for explosive gas atmospheres as defined in IEC 60079-0). It deals only with the risk of caplight becoming a source of ignition. The requirements of IEC 60079-0 do not apply unless specified. Is also applicable to caplights intended for use in mines…