Search

The JT file format specification for 3D visualization specifies the sequential order of bytes that comprise the segments of data required to represent a JT file. The JT format is uniquely compressed to minimize file size. The JT file format specification for 3D visualization includes data descriptions that can represent the following data. — facet information (triangles), stored with geometry…

ISO 15589-1:2015 specifies requirements and gives recommendations for the pre-installation surveys, design, materials, equipment, installation, commissioning, operation, inspection, and maintenance of cathodic protection systems for on-land pipelines, as defined in ISO 13623 or EN 14161 for the petroleum, petrochemical, and natural gas industries, and in EN 1594 or EN 12007‑1 and EN 12007‑3 used…

ISO/IEC/IEEE 9945:2009 defines a standard operating system interface and environment, including a command interpreter (or "shell"), and common utility programs to support applications portability at the source code level. ISO/IEC/IEEE 9945:2009 is intended to be used by both application developers and system implementers and comprises four major components (each in an associated volume…

This document specifies a method for the qualitative and quantitative analysis of microparticles of plastic or elastomeric materials in water using a microscopy technique coupled with vibrational spectroscopy. The aim is to generate reliable and comparable data on the potential presence of microplastics in clean waters with micro-Fourier transform infrared spectroscopy (μFTIR) and micro-Raman…

ISO 12492:2012 specifies a test method for the determination of water content of raw rubber and compounded rubber using a coulometric Karl Fischer titration method. It applies to the range for the water content between 0,01 % and 1 %. As this is a very sensitive method, contact of sample with any moisture, even from the surrounding environment, must be eliminated as much as possible.

This document specifies basic content and relevant parameters to be reported in material data sheets. Individual additions and extensions are permissible. This document is intended for manufacturers of PBF-LB/M or PBF-EB/M equipment, powder suppliers, service providers and users of the additively manufactured components.

This document specifies the determination of Cr(VI) in solid waste material and soil by alkaline digestion and ion chromatography with spectrophotometric detection. This method can be used to determine Cr(VI)-mass fractions in solids higher than 0,1 mg/kg. NOTE       In case of reducing or oxidising waste matrix no valid Cr(VI) content can be reported.

This document specifies a method for the determination of 5 oestrogens, in whole water samples listed in Table 1. The method uses solid-phase extraction (SPE-disks and/or cartridges) followed by liquid or gas chromatography-mass spectrometry (tandem mass spectrometry and/or High resolution mass spectrometry). It is applicable to the analysis of selected estrogens in surface water containing…

This standard specifies the characterization of ceramic slurry for use as feedstock in vat photopolymerization additive manufacturing (AM) process. The characterization includes the composition and properties of the slurry, such as solids content, dynamic viscosity, particle size distribution, chemical composition, and solid dispersion stability. This standard also provides available methods…