Search

ISO 23273-1:2006 specifies the essential requirements for the functional safety of fuel cell (FCV) with respect to hazards to persons and the environment inside and outside of the vehicles caused by the operational characteristics of the fuel cell power system. It does not apply to manufacturing, maintenance or repair of the vehicles. The requirements in ISO 23273-1:2006 address both normal…

Specifies the minimum operational and performance requirements, methods of testing and required test results for Class B shipborne AIS equipment using CSTDMA techniques. Takes into account other associated IEC International Standards and existing national standards. Is applicable for AIS equipment used on craft that are not covered by the mandatory carriage requirement of AIS under SOLAS Chapter…

ISO 22718:2006 gives general guidelines for the detection and identification of the specified micro-organism Staphylococcus aureus in cosmetic products. Micro-organisms considered as specified in this International Standard might differ from country to country according to national practices or regulations. In order to ensure product quality and safety for consumers, it is advisable to perform an…

This CSA Standard is a joint Standard with UL 224. 1 Scope 1.1 This Standard specifies the requirements for insulating tubing that is usually round in cross-section and that consists entirely of extruded compounds whose characteristic constituents are thermosetting, elastomeric, or thermoplastic polymers (see Table 1 for materials and ratings). These requirements also cover heat-shrinkable…

The International Standard ISO 9712:2005 is adopted without modifications (IDT) as a CGSB Standard CAN/CGSB-48.9712-2006/ISO 9712:2005 and has been approved as a National Standard of Canada by the Standards Council of Canada. 1 Scope This International Standard specifies the qualification and certification of personnel involved in non-destructive testing (NDT). It is applicable to…

This National Standard of Canada is based on International Standard CEI/IEC 60335-2-5:2002 +A1 :2005. 1 Scope This clause of Part 1 is replaced by the following. This International Standard deals with the safety of electric dishwashers for household use that are intended for washing and rinsing dishes, cutlery and other utensils, their rated voltage being not more than 250 V for single-phase…

This National Standard of Canada is based on International Standard CEI/IEC 61000-3-3:1994 +A1 :2001. 1 Scope This part of IEC 61000-3 is concerned with the limitation of voltage fluctuations and flicker impressed on the public low-voltage system. It specifies limits of voltage changes which may be produced by an equipment tested under specified conditions and gives guidance on methods…

Object The object of the Code is to specify requirements for the installation and maintenance of electrical equipment to help ensure safe electrical installation. The electrical safety of industrial and similar installations is also ensured through compliance with the objective-based fundamental safety principles of IEC 60364-1 through the implementation of a quality management program or…

This National Standard of Canada is based on ANSI/WCMA A100.1-2002. 1. SCOPE & FOREWORD 1.1 The members of the Window Covering Manufacturers Association, Inc. (WCMA), recognizing that unfortunate accidents, including strangulation, have occurred among young children using certain products having flexible loops made or imported by members of the industry, have prepared this Standard in…

This National Standard of Canada is based on International Standard ISO 8835-4:2004. 1 Scope IEC 60601-1:1988, Clause 1 applies except as follows. Addition: This part of ISO 8835 specifies particular requirements for the essential performance of anaesthetic vapour delivery devices (AVDDs), as defined in 3.1. This part of ISO 8835 is applicable to AVDDs which are a component of an anaesthetic…