Search

This National Standard of Canada is equivalent to International Standard ISO 105-A03:1987. It describes the grey scale for determining staining of adjacent fabrics in colour fastness tests, and its use. A precise colorimetric specification of the scale is given as a permanent record against which newly prepared working standards and standards that may have changed can be compared.

This National Standard of Canada is based on International Standard IEc 300:1984. It outlines guidelines for the selection and implementation of reliability and maintainability activities, appropriate to each of the defined phases of the life of industrial and commercial products in all technologies.

This National Standard of Canada is equivalent to American National Standards Institute (ANSI) standard T1.601-1988. The scope of this standard is as follows: (1) It describes the transmission technique used to support full-duplex service on a single twisted-wire pair (2) It specifies both the input signal with which the NT must operate and the output signal that the NT must produce (3…

This National Standard of Canada is equivalent to American National Standards Institute (ANSI) standard ANSI T1.602-1989. It specifies the Link Access Procedure on the D-channel, LAPD. The purpose of LAPD is to convey information between layer-3 entities across the ISDn user-network interface using the D-channel. LAPD is a protocol operating at the data link layer of the OSI architecture…

This National Standard of Canada is equivalent to International Standard ISo 8831-1989. 1.1 Scope This International Standard is an application layer standard within the Open Systems Interconnection framework set up by ISO 7498. It defines the concepts and services for job transfer and manipulation. This International Standard requires that the user of JTm - specifies the open…

This National Standard of Canada is equivalent to International Standard ISo 8832-1989. 1.1 Scope This International Standard specifies the behaviour to be exhibited by an implementation claiming to conform to this International Standard. It specifies both dynamic conformance and static conformance. It can be referenced by other OSI Standards (using the notation defined in the JTm…

This National Standard of Canada is equivalent to American National Standards Institute standard ANSI/BHMA A156.11-1985. 1.1 This standard establishes requirements for Cabinet Locks used on doors, drawers and furniture. Cycle tests, operational tests, strength tests and finish tests are included. 1.2 Tests described in this Standard are performed under laboratory conditions. In…

This National Standard of Canada is equivalent to American National Standards Institute standard ANSI/BHMA A156.14-1985. 1.1 This Standard establishes requirements for Sliding and Folding Door Hardware. Cycle tests, static load, static friction, kinetic friction and finish tests are included. Hardware for light to very heavy doors is covered including both residential and industrial…

This National Standard of Canada is equivalent to International Standard ISO 4915-1981. It classifies, designates, describes and illustrates the various kinds of stitch types used in hand- and machine-sewn seams.

This National Standard of Canada is equivalent to International Standard ISO 4916-1982. 1 Scope and field of application This International Standard classifies, illustrates and designates the various kinds of stitched seams. It is not intended to be fully comprehensive but to illustrate a number of the most used seam types. It is applicable to seams used most particularly in the…