Search

This National Standard of Canada is equivalent to International Standard CEI/IEC 601-2-38:1996 (first edition, 1996-10). 1 Scope and object This clause of the General Standard applies, except as follows: 1.1 Scope Addition: This Particular Standard specifies requirements for safety of ELECTRICALLY OPERATED HOSPITAL BEDS, hereinafter referred to as BED, as defined in 2.2.101. 1.2 Object…

This National Standard of Canada is based on International Standard ISO 15078:1998 (first edition, 1998-07-01). 1 Scope This International Standard specifies the operational pattern for log loader controls. Two alternative two-lever systems are specified. This International Standard applies to two-lever control systems for grapple-type log loaders used in mobile and self-propelled…

ISO 14889:2002 specifies fundamental requirements for uncut finished spectacle lenses. This International Standard is not applicable to protective spectacle lenses. ISO 14889:2002 takes precedence over the corresponding requirements of other standards, if differences exist.

ISO 4527:2003 specifies the requirements and test methods for autocatalytic nickel-phosphorus alloy coatings applied from aqueous solutions on to metallic substrates. This International Standard does not apply to autocatalytic nickel-boron alloy coatings, nickel-phosphorus composites and ternary alloys.

ISO/TR 7861:2002 presents injury risk curves that can be used for injury risk assessment in the evaluation of occupant protection in road-vehicle frontal impact. The measurements were made on frontal-impact crash test dummies which present acceptable levels of biofidelity response in accordance with ISO 12349-1 and ISO 12349-2 and which are used in the frontal-impact test procedures of existing…

This National Standard of Canada is based on International Standard CEI/IEC 60871-1:1997 (second edition, 1997-10). 1 Scope and object This part of IEC 60871 is applicable to both capacitor units and capacitor banks intended to be used, particularly, for power-factor correction of a.c. power systems having a rated voltage above 1 000 V and frequencies of 15 Hz to 60 Hz. This part of IEC…

This National Standard of Canada is based on International Standard ISO 10079-2:1999 (second edition, 1999-08-15). 1 Scope This part of ISO 10079 specifies safety and performance requirements for manually powered medical suction equipment intended for oro-pharyngeal suction. It covers equipment operated by foot or by hand or both (see Figure 1). Non-electrical suction equipment which may be…

This National Standard of Canada is based on International Standard ISO 10079-3:1999 (second edition, 1999-08-15). 1 Scope This part of ISO 10079 specifies safety and performance requirements for medical suction equipment powered from a vacuum or pressure source (see Figure 1). In particular it applies to connections for pipelines and Venturi attachments. Suction equipment with components…

This National Standard of Canada is based on International Standard ISO 5361:1999, first edition). 1 Scope This International Standard specifies requirements for the dimensions, basic properties and method of size designation of the most commonly used types of oro-tracheal and naso-tracheal tube made of plastics materials and/or rubber (plain and cuffed), and requirements for tracheal tube…

ISO 15011-2:2003 provides guidance on the determination of emission rates of gases generated by arc welding using a fume box technique. It describes the test principle, gives a possible fume box arrangement and considers methods for sampling and analysis. The following gases that can be produced during arc welding are covered: - carbon monoxide (CO); - carbon dioxide (CO2); - nitrogen oxide (NO…