Search

1.1 This standard provides the requirements for modular built relocatable temporary structures. 1.2 Relocatable structures for temporary use are a form of modular construction, built in an approved offsite facility, designed...

Note: The standards development activity for this NOI (originally published on April 25, 2023) was updated by the responsible SDO on February 13, 2024. Note: As requested by the responsible SDO, this NOI being reissued as the...

1 Scope This part of ISO 15027 specifies performance and safety requirements for abandonment suits in emergency situations in work and leisure activities to protect the body of a user against the effects of cold water...

Note: As requested by the responsible SDO, this NOI being reissued as the standard was in the initial stages of development for more than 12 months. An additional comment period of February 6 to February 27, 2024 (originally...

1.1 These requirements cover bare and covered ferrules intended for field wiring and factory wiring for use in accordance with the National Electrical Code, ANSI/NFPA-70 and Canadian Electrical Code, CSA C22.1. 1.2 These...

1.1 These requirements cover pressure regulators for use with LP-Gas equipment. NOTE: For the purposes of this standard the terms “LP-Gas” and “Propane” are interchangeable. 1.2 Regulators covered by these requirements are...

Scope: This clause of Part 1 is replaced by the following. This International Standard specifies safety requirements for electrically operated commercial refrigerating appliances that have an incorporated compressor or that...

Scope: The proposed standard will establish a glossary of terms and definitions on low carbon construction along the full life cycle of construction, applicable to both operational and embodied carbon emission reductions. The...

1.1 This Standard applies to enclosures for electrical equipment intended to be installed and used in non-hazardous locations in accordance with the Canadian Electrical Code, Part I, CSA C22.1, the provisions of the National...

1.1 General This Standard covers the test requirements used to measure battery charger energy consumption for battery chargers intended to be operated from 115 V ac, 60 Hz line voltage connected by plug to wall receptacles or...

This Standard will become a NSC 1.1 Application This Standard applies to single- and multi-section buildings supported on longitudinal floor beams, or perimeter rim joists designed to perform as beams. 1.2 Issues addressed...

[Add the following] This Standard applies to the safety of such equipment designed and constructed for installation and use in accordance with CSA C22.1, Canadian Electrical Code, Part I . Replacement: This part of IEC 61558...