Search

1.1 This method is for the determination of the water permeability of woven, knitted and non-woven geotextiles in a direction normal to the plane of the geotextile. 1.2 This procedure is not applicable to the measurement of...

This part of ISO 105 specifies methods intended for determining the resistance of the colour of textiles of all kinds and in all forms to domestic or commercial Iaundering procedures used for normal household articles...

1.1 This method describes a means for calculating the cetane index of diesel fuels (without cetane improvers) from the aniline point, distillation, density and viscosity. The index, as computed from the prescribed formula, is...

1.1 This method describes a procedure for determining the filter plugging tendency of diesel fuels at low temperature usually due to the formation of wax crystals (see Note after par. 6.1). 1.2 The method applies to all...

1.1 This method describes a procedure for determining the filter plugging tendency of diesel fuels at low temperature usually due to the formation of wax crystals (see Note after par. 6.1). 1.2 The method applies to all...

1.1 This method is used to determine the lead content of gasolines, including those containing ethanol. Lead in the range of 1 to 1100 mg/L can be measured. 1.2 The testing and evaluation of a product against this method may...

This part of IEC 60896 applies to all stationary lead-acid cells and monobloc batteries of the valve regulated type for float charge applications, (i.e. permanently connected to a load and to a d.c. power supply), in a static...

This part of ISO 9360 specifies certain requirements for heat and moisture exchangers (HMEs), including those incorporating breathing system filters, intended for the humidification of respired gases for use primarily with...

This part of ISO 9360 is based on ISO 9360-1:2000 and specifies certain requirements and test methods for heat and moisture exchangers (HMEs) without machine connector ports, including those incorporating breathing system...

This technical report recommends the procedures to assess the disturbance levels produced by the emission of the devices, equipment and systems installed in non-public networks in industrial environment as far as the low...

This technical report describes the electromagnetic disturbance phenomena of voltage dips and short interruptions in terms of their sources, effects, remedial measures, methods of measurement, and measurement results (in so...

This part of IEC 61000 deals with emission of disturbances due to voltage fluctuations and flicker. The recommendations in this Technical Specification are applicable to electrical and electronic equipment that has a rated...