Search

1.1 These requirements cover battery-operated mobile platforms with or without a payload, as specified in 1.2. These devices are intended to be used indoors only or as outdoor use devices in a commercial or industrial...

2. Scope and Field of Application 2.1 Type of Equipment This Standard applies to welded composite enclosures of cast and wrought aluminium and aluminium alloy enclosures pressurized with dry air, inert gases, eg, sulphur...

2. Scope and Field of Application 2.1 Type of Equipment This Standard applies to fusion welded wrought steel enclosures pressurized with dry air, inert gases, eg, sulphur hexafluoride, carbon tetrafluoride, or nitrogen or a...

2. Scope and Field of Application 2.1 Type of Equipment This Standard applies to fusion welded wrought aluminium and alu minium alloy enclosures pressurized with dry air, inert gases, eg, sulphur hexafluoride, carbon...

This Standard sets forth minimum requirements for primary carrier, secondary containment, integral primary/secondary, normal vent and vapour recovery, nonmetallic pipe, fittings, and systems (products) intended for use...

Note: The standards development activity and project need for this NOI (originally published on February 8, 2022), was updated by the responsible SDO on August 3, 2022. The project need was updated on September 7, 2022. This...

1.1 This Standard provides requirements for the design, fabrication, installation, and maintenance of single-membrane structures that are either reinforced or unreinforced and that are air-supported, frame-supported, or cable...

1.1 Inclusions 1.1.1 This International Standard specifies general requirements for the characterization of a sterilizing agent and for the development, validation and routine monitoring and control of a sterilization process...

1.1 These requirements cover pressure regulators for use with LP-Gas equipment. NOTE: For the purposes of this standard the terms “LP-Gas” and “Propane” are interchangeable. 1.2 Regulators covered by these requirements are...

1 General 1.1 Scope Replace this clause of the RD with the following: 1.1.1 Equipment covered by this Standard This Standard applies to UNINTERRUPTIBLE POWER SYSTEMS (UPS). The primary function of the UPS for this Standard is...

Scope This clause of part 1 is replaced by: This standard deals with the safety of electric instantaneous water heaters for household and similar purposes and intended for heating water below boiling temperature, their rated...

1.1 This Standard specifies the requirements for low-halogen aboveground (Type AG) reinforced thermosetting resin conduit (RTRC) and fittings for installation and use in accordance with CSA C22.1, Canadian Electrical Code...