Search

Note: This notice of intent was withdrawn by the responsible SDO on October 31, 2023. This Standard covers seamless pipe, electric-welded pipe (flash-welded pipe and low-frequency electric- welded pipe excluded) and submerged...

1.1 Introduction This document defines the service DataStore:1, which identifies Version 1 of the service named DataStore. This Publicly Available Specification is applicable to Standardized DCPs of the UPnP Forum which...

This standard specifies procedures, managed objects, and protocols for bridges and end systems that provide identification and replication of packets for redundant transmission, identification of duplicate packets, and...

This Standard specifies an interface of a BioAPI C# framework and BioAPI C# BSP which will mirror the corresponding components specified in ISO/IEC 30106‑1. The semantic equivalence of this part of ISO/IEC 30106 will be...

This Standard defines various code points and fields that establish properties of a video or audio stream that are independent of the compression encoding and bit rate. These properties may describe the appropriate...

1.1 This standard applies to flat rolled glass having a layer of meshed wire completely imbedded in the sheet, intended for use in skylights and general glazing in building construction where fire retardation, security and...

This Technical Report specifies the syntax and semantics for object finalization in COBOL. The purpose of this Technical Report is to promote a high degree of portability in implementations of object finalization, even though...

This International Standard specifies requirements for low-pressure hose assemblies intended for use with the following medical gases: oxygen nitrous oxide medical air helium carbon dioxide xenon specified mixtures of the...

This document specifies the core conformance requirements for service level agreements (SLAs) for cloud services based on ISO/IEC 19086-1 and guidance on the core conformance requirements. This document is for the benefit of...

1.1 This Part is intended to be read together with the Standard for Fuseholders – Part 1: General Requirements, hereafter referred to as Part 1. The titles of the Clauses in this Part correspond to the similarly titled...

This Standard provides test procedures for determining the performance of packaged, self-contained or factory matched hydrogen generation systems with a capacity less than 400 m 3 /h at 0 °C and 101,325 kPa, referred to as...

This International Standard applies to bare, hard-drawn, round, aluminum-clad wires of different electrical and mechanical properties, in the diameter ranges shown in table 5, for electrical purposes, before stranding. It is...