Search

1.1 This Standard specifies requirements for the installation of packaged solar domestic hot water (SDHW) systems that meet the requirements of the CSA F379 Series. Note: SDHW systems include those designed to (a) provide hot...

1.1 This Standard applies to encapsulated isolating transformers for use as a circuit continuity device, intended to be installed in airport field lighting series circuits for use in nonhazardous locations in accordance with...

1.1 This Standard applies to ac and dc motors with inherent overheating protection designed to be used in accordance with the Canadian Electrical Code, Part I, as follows: a) motors with a voltage rating not exceeding 600 V...

1.1 This Standard describes zinc-coated steel wire strand suitable for use as guys, suspension strand, span wires, and overhead ground wire strand. Overhead ground wire strand for electric power transmission is produced free...

This International Standard specifies the signalling protocol for the support of the Short Message Service (SMS) at the Q reference point between Private Integrated services Network eXchanges (PINXs) connected together within...

1.1 This Standard covers the requirements for dead-end/suspension composite insulators used on overhead distribution lines operating at nominal voltages up to and including 75 kV. Dead-end insulators support the line...

1.1 This Standard covers the requirements for line post composite insulators used on overhead distribution lines operating at nominal voltages up to and including 75 kV. Line post insulators support the line conductor...

1.1 This Standard covers receptacles with attachment plugs; receptacles with attachment plugs interlocked with circuit breakers; receptacles with attachment plugs interlocked with switches; and cable and cord connectors...

1.1 Types of valves in the scope of this Standard The requirements of this Standard apply to automatic valves used in compressed natural gas dispensing systems as specified in Table 1. Table 1 - Included and excluded valves...

Note: The scope of this Notice of Intent (originally published on November 28, 2023) was updated by the responsible SDO on July 16, 2024. 1.1 This Standard applies to encapsulated isolating transformers for use as a circuit...

This International Standard defines the mapping functions in exchanges of Private Integrated Services Networks (PISNs) required for the utilization of scenarios in which 64 kbit/s circuit mode connections are sub-multiplexed...

This part of IEC 61000 relates to the immunity requirements and test methods for electrical and electronic equipment to conducted, common mode disturbances in the range d.c. to 150 kHz. The object of this standard is to...