Search

This standard provides guidance for developing policies, procedures, processes and documentation that support the continuing reliability, accuracy and authenticity of electronic records to: ensure that electronic records can...

This Standard specifies requirements and test methods only for hoists and body-support units intended for the transfer of disabled persons as classified in ISO 9999:2002: ⎯ 12 36 03 Mobile hoists with sling seats ⎯ 12 36 04...

1.1 These requirements cover stationary centrifugal fire pumps intended for use in water-supply systems for fire-protection service.1.2 The pumps covered by these requirements are intended for installation and use in...

This standard applies to chairs used in office environments including chairs for computer uses and non-computer (occasional) uses i.e. conference (w/Table) and guest applications (Side chair). The dimensions given in this...

1. Scope This part of ISO/IEC 14165 describes the physical interface portions of a high performance serial link that supports the higher Upper Level Protocols (ULPs) associated with HIPPI, IPI, SCSI, IP and others. This...

This Standard applies to isolating switches, without enclosures, for use indoors at voltages from 751 to 46 000 V ac or for installation in switchgear assemblies (see CSA Standard C22.2 No. 31) or similar equipment for use...

The scope of this project is to develop a slurry pumping system energy standard referencing actual energy usage versus essential energy required. The standard will be used to assess energy usage of slurry pumping systems...

This clause presents the scope, purpose, organization, and candidate uses of this International Standard. This International Standard supports the interest of software users in consistent, complete, accurate, and usable...

1 Scope 1.1 1.1.1 This Standard establishes requirements for the planning, design, implementation, maintenance, evaluation, and continual improvement of wayfinding systems for HCFs. 1.1.2 This Standard addresses the following...

1.1 This Standard specifies the requirements for trace heaters, surface heaters, and heating device sets for use on system voltages not exceeding 750 V that are intended to be installed in accordance with the Canadian...

1 Scope 1.1 This Standard applies to liquefied natural gas metallic hose assemblies which are used on LNG dispensers to connect the dispenser to the refueling nozzle and for gas lines which carry vented gas back to a safe...