Search

Scope This part of IEC 60079 specifies the requirements for the construction and testing of oil immersed electrical equipment, oil-immersed parts of electrical equipment and Ex components in the type of protection oil...

1.1 This Standard covers polyamide (PA) pipe, tubing, and fittings for use in gas mains and services, including the gathering, transmission, and distribution of gases that can contain aromatic hydrocarbons. 1.2 This Standard...

1.1 This Standard covers polyethylene (PE) pipe, tubing, and fittings for use in gas mains and services, including gathering, transmission, and distribution of fuel gases containing not more than 1% aromatic hydrocarbons. 1.2...

1.1 This Standard specifies the requirements for distribution transformers with the exception of those distribution transformers that are covered by CSA C2.2, C227.3, and C227.4. Note: The operation of transformers complying...

Note: The scope for this NOI (originally published on November 22, 2022) were updated by the responsible SDO on February 27, 2024. 1 Scope 1.1 General This Standard specifies requirements for the maintenance of electrical...

This standard establishes sampling plans and procedures to determine the acceptability with respect to flammability of soft floor coverings using a sequential sampling procedure. The procedures described in this standard are...

This Standard specifies an interface of a BioAPI Java framework and BioAPI Java BSP, which will mirror the corresponding components, specified in ISO/IEC 30106‑1. The semantic equivalent of this standard is maintained in this...

Replacement: This International Standard applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of INFANT TRANSPORT INCUBATOR equipment, as defined in 201.3.211 of this standard, also referred to as ME EQUIPMENT. If a clause...

This part of ISO/IEC 14776 defines the command set extensions to facilitate operation of SCSI direct access block devices. The clauses in this standard, implemented in conjunction with the applicable clauses of SPC-4, specify...

1.1 This Standard applies to suspension and dead-end composite insulators used on ac overhead transmission lines with a nominal voltage greater than 75 kV and a frequency not greater than 100 Hz. 1.2 The objectives of this...

1.1 This Standard specifies requirements for concentric-lay aluminum stranded conductors, with or without a central core of reinforcing steel strand. These conductors are intended for overhead installation on single-phase or...

Scope 1.1 This Standard specifies energy efficiency and performance requirements for LED luminaires of the directional and non-directional type used for general illumination, including those with a significant decorative...