Refine Results
Displaying 8809 - 8820 of 10759
Notice of Intent
Overhead transmission lines - Design criteria
This International Standard specifies the loading and strength requirements of overhead lines derived from reliability-based design principles. These requirements apply to lines 45 kV and above, but can also be applied to...
Washer-disinfectors — Part 2: Requirements and tests for washerdisinfectors employing thermal disinfection for surgical instruments, anaesthetic equipment, bowls, dishes, receivers, utensils, glassware, etc
1 Scope This part of ISO 15883 specifies particular requirements for washer-disinfectors (WD) that are intended for use for the cleaning and thermal disinfection, in a single operating cycle, of re-usable medical devices such...
Notice of Intent
Sterilization of health care products — Moist...
Scope 1.1 Inclusions 1.1.1 This part of ISO 17665 specifies requirements for the development, validation and routine control of a moist heat sterilization process for medical devices. NOTE Although the scope of this part of...
Washer-disinfectors — Part 5: Test soils and methods for demonstrating cleaning efficacy
1 Scope This Technical Specification includes the test soils and methods that can be used to demonstrate the cleaning efficacy of washer-disinfectors (WD) according to the ISO 15883 series of standards. The inclusion of the...
Notice of Intent
Aviation Turbine Fuel
1. SCOPE 1.1 This standard applies to two grades of aviation turbine fuel (military grades F-34 and F-44) consisting of conventional hydrocarbons, synthetic hydrocarbons, naturally occurring non-hydrocarbons and additives as...
Notice of Intent
Adhesive labels
1.1 This Standard applies to permanent adhesive labels and nameplates intended for use indoors or outdoors on application surfaces that are essentially clean, smooth, flat, or simple curved.* * See Annex A 1.2 This Standard...
Notice of Intent
Medical electrical equipment - Part 2-37: Particular...
Scope: CSA C22.2 NO. 60601-2-37:08 (R2023) Addition: This International Standard applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of ULTRASONIC DIAGNOSTIC EQUIPMENT as defined in 201.3.217, hereinafter referred to as ME...
Notice of Intent
Test methods for machine readable travel documents...
This document provides a set of instructions for evaluation of MRPs which may incorporate contactless integrated circuits. This evaluation is an instrument to establish the ability in principle of a specific type of document...
Notice of Intent
Performance requirements for pressurized flushing...
1.1 This Standard covers pressurized flushing devices (PFDs) intended to flush water closets, urinals, and other plumbing fixtures and specifies requirements for materials, design, methods of operation, test methods, and...
Notice of Intent
Anti-siphon fill valves for water closet tanks
1.1 This Standard covers anti-siphon fill valves intended to be installed in water closet tanks. Note: In this Standard, anti-siphon fill valves are also referred to as "devices". 1.2 In this Standard, "shall" is used to...
Notice of Intent
Performance requirements for water temperature...
1.1 This Standard covers water temperature limiting devices intended to limit the hot or tempered water temperature supplied to fittings for fixtures such as sinks, bidets, lavatories, and bathtubs to reduce the risk of...
Notice of Intent
General requirements for pressure-retaining systems...
1 Scope 1.1 This Standard specifies the technical requirements for the design, procurement, fabrication, installation, modification, repair, replacement, testing, examination, and inspection of, and other work related to...