Search

Replacement: This International Standard applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of CT SCANNERS, hereafter also referred to as ME EQUIPMENT. If a clause or subclause is specifically intended to be applicable to...

1.1 This Standard specifies minimum requirements for the design, inspection, testing, maintenance (modifications and repairs), and safe operation of overhead cranes, monorails, hoists, trolleys, jib cranes, gantry and wall...

1.1 This Standard covers the following products: (a) built-in cook tops: (i) electric powered: (1) radiant; (2) halogen; (3) coil; (4) induction; and (5) grill; and (ii) gas powered: (1) sealed burner; and (2) open burner...

Scope of this Standard This Standard specifies requirements pertaining to the following: (a) definitions; (b) construction; (c) equipment complying with Standards; (d) safety and protection; (e) materials and quality of work...

1.1 This Standard applies to newly produced non-metallic dip tubes intended for use in water heaters. 1.2 Compliance of a dip tube with this Standard does not imply that such dip tube is acceptable for use in water heaters...

1.1 The requirements in this standard cover sealed wire connector systems, including insulating caps, covers, resins, tubing, and tapes provided with, or for use with, specific wire connectors. These systems are intended for...

1.1 General This Standard specifies requirements for the performance, design, testing, marking, and instructions of energy absorbers and lanyards, including lineman's pole straps and integrally connected lanyards and energy...

1.1 This Standard specifies the test methods and marking requirements, and references energy efficiency levels for three-phase induction motors. Note: The test methods contained in this Standard are not limited to specific...

ISO 17510 will replace Z17510-1 and Z17510-2 IEC 60601-1:1988, Clause 1 applies, except as follows. Amendment (add at the end of the Subclause 1.1): This part of ISO 17510 specifies requirements for equipment intended for...

This part of IEC 60896 applies to all stationary lead-acid cells and monobloc batteries of the valve regulated type for float charge applications, (i.e. permanently connected to a load and to a d.c. power supply), in a static...

1 .1 1 This standard applies to 3 phase high voltage power circuit breakers rated greater than 1000Vac and up to 52 kV for use in nonhazardous locations in accordance with the Canadian Electrical Code, Part I. 1.2 This...

This International Standard describes methods for the determination of the total sulfur and total chlorine content in solid biofuels. This International Standard specifies two methods for decomposition of the fuel and...