Search

1.1 This standard applies to colored, flexible, retrorflective marking material in both sheeting and tape form, coated on the nonreflective side with an adhesive and protected by a removable liner.

This method is intended for the determination of the mass per unit area of geotextile fabrics. It is primarily for use in the laboratory.

1.1 This method determines the bursting strength of geotextiles. It is intended primarily for nonwoven geotextiles, although woven or composite fabrics may also be tested for specific applications.

1.1This standard provides definitions of terms relating to geotextiles and geomembranes.

This part of IEC 60855 is applicable to insulating foam-filled tubes and solid rods, of a circular cross-section, made of synthetic materials with reinforced fibreglass and intended to be used in the manufacture and...

This Standard applies to inductive current transformers for transient performance applications. The requirements and tests specified in this Standard complement the requirements and tests specified in CAN/CSA-C60044-1.

Geotextiles - Quality of Geotextiles Used in Road Engineering

1.1 This Standard describes the requirements for the design and installation of a fire alarm system with or without voice communication capability, as defined in Section 3, Glossary. NOTE 1: This Standard is intended to apply...

1.1 This Standard covers manual stations and their accessories for installation in ordinary locations, indoor and outdoor, for use in fire alarm systems. 1.2 A manual station having a pre-wound signalling mechanism and...

These requirements apply to Factory-Built Type 'A' Chimneys, which do not require field fabrication. They are for use with gas and liquid fuel-fired residential appliances and building heating equipment, where the appliance...

These requirements cover the design and construction of Type L vents intended for the venting of flue gases having temperatures not exceeding 300 °C. They may also be used where Type B gas vents are used. They are intended...

These Requirements apply to Factory-Built Chimney assemblies which do not require field fabrication. They are for use with gas, liquid and solid fuel-fired residential appliances and building heating equipment, where the flue...