Search

1.1 1.1 This Standard applies to locking-type, pin and sleeve type plugs, receptacles, power inlets, connectors, junction boxes, and live-end covers rated up to 1200 A (for single- and multi-pole) and above 750 V to 35 kV ac...

This International Standard specifies the signalling protocol for the support of the Advice Of Charge supplementary services (SS-AOC) at the Q reference point between Private Integrated services Network eXchanges (PINX)...

1.1 General This Standard covers polyamide (PA) pipe, tubing, and fittings for use in gas mains and services, including the gathering, transmission, and distribution of gases that can contain aromatic hydrocarbons. 1.2...

1.1 Application This Standard applies to single- and multi-section buildings supported on longitudinal floor beams, or perimeter rim joists designed to perform as beams. 1.2 Issues addressed This Standard specifies...

The limits in this International Standard are designed to provide protection for broadcast receivers in the frequency range of 30 MHz to 1 000 MHz when used in the residential environment. Compliance with this standard may...

1.1 General This Standard covers chlorinated polyvinylchloride (CPVC) pipe, tubing, and fittings in the following sizes and uses: a) SDR 11, and Schedules 40 and 80 pipe in pipe sizes whose dimension ratio does not exceed 11...

1.1 This Standard applies to brick made from fired clay or shale that are intended for use as structural and/or facing components in masonry. It includes testing and other requirements pertaining to freeze-thaw durability...

1.1 Inclusions This Standard applies to newly produced compressed natural gas vehicle (NGV) dispenser fuelling hose emergency main line breakaway devices and vent line breakaway devices, herein to be referred to as devices. 1...

.1 This Standard applies to the design and manufacture of UN portable tanks and their approval by the Competent Authority of Canada. Such UN portable tanks shall have a capacity greater than 450 L and may or may not meet the...

1.1 This Standard applies to newly produced, direct gas-fired industrial air heaters of the non-recirculating type, hereinafter referred to as heaters, whose purpose is to offset building heat loss. All air to the heater is...

1.1 General This Standard covers seamless pipe, electric-welded pipe (flash-welded pipe and low-frequency electricwelded pipe excluded) and submerged-arc-welded pipe primarily intended for use in oil or gas pipeline systems...