Search

This clause of Part 1 is applicable, except as follows: Addition: This part of IEC 62841 applies to transportable table saws with – a toothed single blade; or – stacked blades that cut a single groove or slot; or – a moulding...

This clause of Part 1 is applicable except as follows: 1.1 Scope Replacement: This part of IEC 60730 applies to electrically operated door locks for use in, on or in association with equipment, including equipment for heating...

This Standard provides accompanying reference software for Rec. ITU-T H.265 | ISO/IEC 23008-2 as an electronic attachment. The software is an integral part of this document. The use of this reference software is not required...

This Standard (ISO 12614-6:2014) specifies tests and requirements for the pressure regulator, a liquefied natural gas fuel system component intended for use on the types of motor vehicles defined in ISO 3833. ISO 12614-6:2014...

This Standard specifies interchangeable glow-starters used with pre-heat type fluorescent lamps, hereafter called starters. Section 1 specifies the general and safety requirements with which starters shall comply. Section 2...

1.1 This Standard applies to explosion-proof electrical equipment suitable for use in hazardous locations in accordance with CSA C22.1, Canadian Electrical Code, Part I and the requirements of CSA M421. It applies to...

1. Scope This part of ISO/IEC 14776 defines a Reduced Block Command set for logical block devices. The Reduced Block Commands, along with the required SPC-2 commands and their restrictions described in this standard, fully...

This part of IEC 61000 defines the immunity test methods and range of preferred test levels for electrical and electronic equipment connected to low-voltage power supply networks for voltage dips, short interruptions, and...

This Standard specifies the Data Model for a collaborative group. The collaborative group Data Model composes roles which can be played by the participants of a collaborative group, declares the intended role holders...

This part of IEC 61936 provides common rules for the design and the erection of electrical power installations in systems with nominal voltages above 1 kV a.c. and nominal frequency up to and including 60 Hz, so as to provide...

This part 2-5 of IEC 61558 applies to shaver supply units, embodying one or more socketoutlets and a single phase air cooled isolating transformer, having a rated supply voltage not exceeding 250 V a.c., a rated output not...

This Technical Report provides guidance on reviewing the implementation and operation of controls, including technical compliance checking of information system controls, in compliance with an organization's established...