Search

1.1 This guideline lays out the principles of and provides guidance for identification, analysis, evaluation and decision-making in the management of public risks to prevent, reduce or minimize public harm while maximizing...

1.1 This Standard applies to assemblies of resistors, enclosures, and other components that provide high impedance grounding for the purpose of controlling the ground fault current or the voltage to ground of an alternating...

Purpose and scope This standard specifies the characteristics and test methods of polyethylene (PE) pipe and fittings designed for storm sewers, culverts and soil drainage. This standard applies to smooth inside wall open...

This International Standard defines the encoding rules which shall apply to the representation of IPI-IIF image data. The IPI-IIF data format is defined in ISO/IEC 12087-3, called Image Interchange Facility (IIF). It is Part...

PURPOSE This standard specifies the characteristics and test methods relating to solid-wall high-density polyethylene (HDPE) pipe having a hydrostatic design basis greater than or equal to 11 MPa. NOTE — The designer may...

PURPOSE This standard specifies the characteristics and test methods relating to solid-wall high-density polyethylene (HDPE) pipe having a hydrostatic design basis greater than or equal to 11 MPa. NOTE — The designer may...

1.1 These requirements cover bare and covered ferrules intended for field wiring and factory wiring for use in accordance with the National Electrical Code, ANSI/NFPA-70 and Canadian Electrical Code, Part I, CSA C22.1. 1.2...

Thin flexible cards (TFC), the subject of this International Standard, are used to automate the controls for access to goods or services such as mass transit, highway toll systems, car parks, vouchers, stored value, etc. For...

1.1 This Part is intended to be read together with the Standard for Low-Voltage Fuses – Part 1: General Requirements, hereafter referred to as Part 1. The titles of the Clauses in this Part correspond to the similarly titled...

This clause of Part 1 is applicable, except as follows: Addition: This part of IEC 62841 applies to hand-held circular saws, which hereinafter will be referred to as saws. This standard does not apply to saws designed for use...

IEC 62841-1:2014, Clause 1 is applicable, except as follows: Addition: This document applies to hand-held spray guns for non-flammable materials.

1.1 This Standard specifies requirements for Type NS75 and NS90 neutral-supported cables for use on outdoor overhead electrical systems that (a) have nominal voltages of 600 V or less; and (b) are intended for installation in...