Refine Results
Displaying 9577 - 9588 of 9875
Notice of Intent
Standard for Control Units for Fire Alarm Systems
1 Scope 1.1 This Standard covers control units, fire alarm systems and control unit accessories for use in accordance with the Standard for the Installation of Fire Alarm Systems, CAN/ULC-S524, in accordance with CSA-C22.1...
Notice of Intent
Standard Method of Fire Endurance Tests of Building...
1.1 This Standard covers fire endurance tests applicable to walls, partitions, floors, roofs, ceilings, columns, beams, and girders, as well as to some components of these building sub-assemblies. Note: The performance...
Notice of Intent
Explosive atmospheres - Part 7: Equipment protection...
This part of IEC 60079 specifies the requirements for the design, construction, testing and marking of electrical equipment and Ex Components with type of protection increased safety e intended for use in explosive gas...
Notice of Intent
Conduit, tubing, and cable fittings
1.1 These requirements cover FITTINGS for use with cable and conduit intended for installation in accordance with the National Electrical Code, ANSI/NFPA 70, the Canadian Electrical Code (CEC), Part I, CSA C22.1, and the...
Notice of Intent
Medical electrical equipment — Part 2-70: Particular...
1.1 * Scope IEC 60601-1:2005+A1:2012, 1.1 is replaced by: This particular standard is applicable to the BASIC SAFETY and ESSENTIAL PERFORMANCE of SLEEP APNOEA BREATHING THERAPY EQUIPMENT, hereafter referred to as ME EQUIPMENT...
Notice of Intent
Temperature compensation for compressed natural...
This Standard details the safety and performance requirements for temperature compensation control used to prevent compressed natural gas (CNG) dispensing systems from exceeding a safe fill level of vehicle fuel storage...
Notice of Intent
Quick disconnect devices for use with gas fuel...
1.1 This Standard applies to newly-produced, hand-operated quick-disconnect devices, hereinafter also referred to as devices, constructed entirely of new, unused parts and materials which provide a means for connecting and...
Notice of Intent
Transfer switch equipment, over 1000 volts
1.1 These requirements cover automatic, non-automatic, and manual transfer switches, operating at voltages of greater than 1000 Vac, and intended for use in non-hazardous locations in accordance with Annex B, Item 1, the...
Notice of Intent
Automatic electrical controls for household and...
1. Scope This clause of part 1 is replaced as follows: Replacement: 1.1 This part 2-8 applies to electrically operated water valves for use in, on or in association with equipment for household and similar use that may use...
Notice of Intent
Automatic electrical controls - Part 2-6: Particular...
This clause of Part 1 is applicable except as follows: 1.1 Scope Replacement: This part of IEC 60730 applies to automatic electrical pressure sensing controls with a minimum gauge pressure rating of –60 kPa and a maximum...
Notice of Intent
Electromagnetic compatibility (EMC) – Part 4-...
This part of IEC 61000 defines the immunity test methods and range of recommended basic test levels for electrical and electronic equipment with rated current up to 16 A per phase at disturbance frequencies up to and...
Notice of Intent
Explosive atmospheres - Part 29-1: Gas detectors...
This part of IEC 60079-29 specifies general requirements for construction, testing and performance, and describes the test methods that apply to portable, transportable and fixed equipment for the detection and measurement of...