Search

Replacement: This International Standard applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of ELECTRON ACCELERATORS, hereafter referred to as ME EQUIPMENT, in the range 1 MeV to 50 MeV, used for treatment of PATIENTS...

This clause of Part 1 is replaced by the following. This International Standard deals with the safety of electric range hoods and other cooking fume extractors intended for installing above, beside, behind or under household...

.1 This standard designates a system of symbols to be used in the labelling of textiles to indicate the preferred care procedures for restoring the textiles to an acceptable usable condition with respect to the properties...

1.1 This Standard covers insulated multi-pole mating or non-mating splicing wire connectors intended for field wiring and factory wiring for use in accordance with the Canadian Electrical Code, Part I, in Canada, and NFPA 70...

1. Scope This clause of part 1 is replaced as follows: Replacement: 1.1 This part 2-8 applies to electrically operated water valves for use in, on or in association with equipment for household and similar use that may use...

1. Scope This clause of Part 1 is replaced as follows: 1.1 This standard applies to automatic electrical pressure sensing controls with a minimum gauge pressure rating of -60 kPa and a maximum gauge pressure rating of 4,2 MPa...

1. Scope This part of ISO 19901 contains requirements for defining the seismic design procedures and criteria for offshore structures; guidance on the requirements is included in Annex A. The requirements are applicable to...

This part of IEC 60320 is applicable to two-pole appliance couplers for a.c. only, with or without earthing contact, with a rated voltage not exceeding 250 V and a rated current not exceeding 16 A, for household and similar...

1.1.1 This standard applies to newly produced automatic gas ignition systems (see Part III, Definitions) and components thereof other than types utilizing low, extra low, or high voltages, constructed entirely of new, unused...

This part of ISO 19085 gives the safety requirements for horizontal beam panel circular sawing machines with the saw carriage of the front cutting line mounted below the work-piece support, which are manually or powered...

This International Standard deals with safety aspects of power transformers, power supplies, reactors and similar products such as electrical, thermal and mechanical safety. This standard covers the following types of dry...

This part of ISO/IEC 7811 is one of a series of standards describing the characteristics for identification cards as defined in the definitions clause and the use of such cards for international interchange. This part of ISO...