Search

NOTE: The scope for CAN/CGSB-3.511 was updated by the responsible SDO on September 21, 2021 as the incorrect scope had been inadvertently used for the NOI originally published on October 16, 2019. This standard applies to two...

1 SCOPE 1.1 This Standard sets forth minimum requirements for the material properties and performance of liners used for secondary containment under and around the area of tanks that are installed aboveground for the storage...

1.1 This Standard specifies tests and requirements for the flexible fuel line or vent line for service temperatures colder than –40 °C (–40 °F) and cryogenic conditions, a liquefied natural gas fuel system component intended...

1.1 This Standard specifies photometric performance requirements for luminaires that are used for roadway and street lighting applications. 1.2 The following light sources are addressed in this Standard: a) clear HPS lamp; b)...

Scope This International Standard gives guidelines for the evaluation and selection of CASE tools, covering a partial or full portion of the software engineering life cycle. It establishes processes and activities to be...

Scope This clause of Part 1 is applicable except as follows: 1.1 Replacement: This part of IEC 60730 applies to the partial evaluation of thermal motor protectors as defined in IEC 60730-1 for sealed (hermetic and semi...

1.1 This Standard applies to: a) electrostatic air cleaners intended to remove dust and dirt from the air and intended for general indoor residential and commercial use; b) air ionizer type air cleaners; and c) other similar...

This International Standard defines: A quality in use model composed of five characteristics (some of which are further subdivided into subcharacteristics) that relate to the outcome of interaction when a product is used in a...

The Open-edi Reference Model (ISO/IEC 14662:2010, Clause 4) states: "The intention is that the sending, by an Open-edi Party, of information from a scenario, conforming to Open-edi standards, shall allow the acceptance and...

This International Standard defines: A quality in use model composed of five characteristics (some of which are further subdivided into subcharacteristics) that relate to the outcome of interaction when a product is used in a...

The Open-edi Reference Model (ISO/IEC 14662:2010, Clause 4) states: The intention is that the sending, by an Open-edi Party, of information from a scenario, conforming to Open-edi standards, shall allow the acceptance and...

1.1 This Standard specifies methods for measuring electrical power consumption of equipment intended for use in commercial and industrial application when in low power mode(s) (i.e., standby mode, off mode, and network mode)...