Search

1.1 This Standard applies to the construction, performance, and installation procedures for a newly produced automatic damper device (hereinafter referred to as device) constructed entirely of new, unused parts and materials...

1.1 General This Standard details mechanical, physical, and electrical requirements for a newly manufactured appliance that compresses natural gas for vehicles and dispenses directly into a) the vehicle natural gas fuel...

1.1 This Standard applies to wall and ceiling-mounted track lighting systems, rated 347 V, 40 A max, incorporating incandescent, fluorescent, light emitting diodes and high-intensity discharge lighting sources, intended to be...

1.1 This Standard applies to newly produced vented gas fireplace heaters (see Clause 3, Definitions), hereinafter referred to as appliance(s), constructed entirely of new, unused parts and materials, and having input ratings...

This clause of Part 1 is replaced by the following. This International Standard deals with the safety of electrical portable, non-self-propelled motor-operated SPRAY EXTRACTION MACHINES with or without attachments and with or...

1.1 These requirements cover hose nozzle valves that are intended to be used for the control of motor fuels as indicated in 1.2. They are of the type used in motor fuel dispensing equipment. Hose nozzle valves covered by this...

Note: The standard development activity for this NOI (originally published on May 2, 2023) was updated by the responsible SDO on July 25, 2023 . 1.1 This Standard establishes a minimum level of protection and safety of...

1.1 These requirements cover emergency breakaway fittings, swivel connectors and pipe-connecting fittings of the threadless compression type. Connectors and fittings covered by these requirements are intended only for the...

1.1 This Standard describes the design, construction, load rating, installation, erection, inspection, maintenance, repair, modification, test, and operation of lattice and telescopic boom mobile cranes. Note: See Annex A for...

This clause of Part 1 is applicable, except as follows. 1.1.1 Equipment included in scope Replacement: This part of IEC 61010 specifies safety requirements and related verification tests for control equipment of the following...

1.1 Purpose The purpose of this Standard is to provide minimum requirements for the design, construction, and marking of electrical equipment or parts of such equipment for use in Class I and Class II, Division 2 and Class...

1.1 Introduction 1.1.1 The purpose of this standard is to provide minimum requirements for the design, construction, and marking of electrical equipment or parts of such equipment for use in Class I and Class II, Division 2...