Search

1.1 General This Standard details mechanical, physical, and electrical requirements for a newly manufactured appliance that dispenses natural gas for vehicles directly into the vehicle natural gas fuel storage system...

This clause of Part 1 is applicable except as follows: 1.1.1 Equipment included in scope Replacement: Replace the existing text with the following: This part of IEC 61010 specifies safety requirements for electrical equipment...

This part of IEC 62282 applies to stationary packaged, self-contained fuel cell power systems or fuel cell power systems comprised of factory matched packages of integrated systems which generate electricity through...

IEC 60601-1:2005+Amendment 1:2012, Clause 1 applies, except as follows: 201.1.1 Scope IEC 60601-1:2005+Amendment 1:2012, 1.1 is replaced by: This particular standard specifies requirements for the BASIC SAFETY and ESSENTIAL...

This Standard defines the mechanical, electrical, timing, and protocol requirements of the SCSI parallel interface to allow conforming SCSI devices to inter-operate. The SCSI parallel interface is a local I/O bus that may be...

Note: The scope of this Notice of Intent (originally published on July 3, 2024) was updated by the responsible SDO on July 23, 2024. 1.1 This Standard applies to a) electrostatic air cleaners intended to remove dust and dirt...

Note: This notice of intent was withdrawn by the responsible SDO on November 21, 2023. 1.1 This Standard applies to visual signaling devices intended for indoor and/or outdoor installation: a) In Canada only: in accordance...

Note: The project need for this NOI (originally published on July 5, 2023) was updated by the responsible SDO on July 11, 2023 . 1.1 This Standard applies to visual signaling devices intended for indoor and/or outdoor...

Replacement: This part of IEC 61558 deals with the safety of shaver transformers, power supply units incorporating a shaver transformer, and shaver supply units. Shaver transformers incorporating electronic circuits are also...

This service template is compliant with the UPnP Device Architecture version 1.0 [14]. It defines a service type referred to herein as RenderingControl. 1.1 Introduction Most rendering devices contain a number of dynamically...

This Standard applies to controllers and starters, which may include a series mechanical switching device, intended to be connected to circuits, the rated voltage of which does not exceed 1 000 V a.c. This Standard...

Z241.0 - Definitions and General Safety Requirements for Park Model Trailers 1. Scope This Standard provides the definition of the term "park model trailer" as used in the CSA Z241 Series. It also gives general safety...