Search

This part of ISO/IEC 7816 specifies the dimensions and locations for each of the contacts on an integrated circuit card of an ID-1 card type. It also provides information on the way to identify which standards define the use...

1 SCOPE 1.1 This Standard sets forth minimum requirements for the material properties and performance of liners used for secondary containment under and around the area of tanks that are installed aboveground for the storage...

1.1 Statement of scope 1.1.1 ISO/IEC 19778 ISO/IEC 19778 is applicable to collaborative technologies used to support communication among learners, instructors and other participants. The implementation and communicative use...

This clause of Part 1 is replaced by the following. This part of IEC 60335 deals with the safety of electric HEAT PUMPS, including SANITARY HOT WATER HEAT PUMPS, AIR CONDITIONERS, and DEHUMIDIFIERS incorporating motor...

This Standard will encompass two levels of interface, defining operation over distances less than 10 m. The physical layer will specify electrical, mechanical, and thermal characteristics of connectors and cards. The logical...

1.1 Introduction This document defines the service DataStore:1, which identifies Version 1 of the service named DataStore. This Publicly Available Specification is applicable to Standardized DCPs of the UPnP Forum which...

Scope: CSA ISO/IEC/IEEE 8802-11:19 The scope of this standard is to define one medium access control (MAC) and several physical layer (PHY) specifications for wireless connectivity for fixed, portable, and moving stations...

Scope: CSA ISO/IEC/IEEE 8802-11:19 The scope of this standard is to define one medium access control (MAC) and several physical layer (PHY) specifications for wireless connectivity for fixed, portable, and moving stations...

This document specifies the test calibration methods and apparatus used when calibrating test tools for cryptographic modules under ISO/IEC 19790 and ISO/IEC 24759 against the test metrics defined in ISO/IEC 17825 for...

1. Scope This part of ISO/IEC 18033 is general in nature, and provides definitions that apply in subsequent parts of ISO/IEC 18033. The nature of encryption is introduced, and certain general aspects of its use and properties...

This Standard is a specification which provides security service enhancements for the protocol defined in IEEE Std 1888-1, IEEE Standard for Ubiquitous Green Community Control Network Protocol. This standard describes...

This Standard defines the following: - dimensions of a Biometric System-on-Card type S1 and type S2; - position and size of the biometric capture device; - minimum requirements to a Biometric System-on-Card with respect to -...