Search

1.1 This Standard applies to a) electrostatic air cleaners intended to remove dust and dirt from the air and intended for general indoor residential and commercial use; b) air ionizer type air cleaners; c) other similar...

This Standard is applicable to the finished surface or covering of a floor extending to a maximum depth of 65 mm. This method is also applicable to the following: A Materials which cannot be tested as described in Clause 1.1...

1.1 This Standard includes requirements for the safe operation of various types of suspended equipment (see Figure 1) used to gain access to interior or exterior, or both, sides, ceilings and soffits of buildings or...

CISPR 16-2-1 Ed. 3.1: This part of CISPR 16 is designated a basic standard that specifies the methods of measurement of disturbance phenomena in general in the frequency range 9 kHz to 18 GHz and especially of conducted...

IEC 62841-2-21:2017 applies to hand-held drain cleaners (drain cleaners are also known as pipe cleaners) the rated voltage is not more than 250 V for single-phase a.c. or d.c. tools, and 480 V for three-phase a.c. tools. The...

1.1 This Standard provides procedures for evaluating polymeric materials and parts made from polymeric materials intended for application in electrical equipment covered by the Canadian Electrical Code, Part II (CE Code, Part...

1.1 This Standard specifies requirements for the design, construction, installation, inspection, testing, maintenance, alteration, and repair of suspended platforms. 1.2 This Standard applies to suspended platforms that are...

This Standard is intended to assist all classes of health care facilities (HCFs) to manage the potential risks associated with plumbing installation and maintenance. This Standard addresses the special requirements of...

1 Scope This part of IEC 61347 specifies particular safety requirements for electronic controlgear for use on d.c. supplies up to 250 V and a.c. supplies up to 1 000 V at 50 Hz or 60 Hz and at an output frequency which can...

This clause of part 1 is applicable except as follows: 1. Scope Replacement: This part 2 applies to equipment intended for in vitro diagnostic (IVD) medical purposes, including self-test IVD medical purposes. IVD medical...

ISO/IEC 10373 defines test methods for characteristics of identification cards as defined in ISO/IEC 7810. Each test method is cross-referenced to one or more base standards, which may be ISO/IEC 7810 or one or more of the...

1.1 This Standard applies to cord connected and direct plug-in transformers for use indoors, designed to be used on a nominal 120-V branch circuit in nonhazardous locations in accordance with the Rules of the Canadian...