Search

This clause of Part 1 is applicable, except as follows: Addition: This part of IEC 62841 applies to transportable drain cleaners. NOTE 101 Drain cleaners are also known as pipe cleaners. This standard does not apply to hand...

Note: The project need of this Notice of Intent (originally published on January 17, 2023) was updated by the responsible SDO on January 31, 2023. These requirements cover components intended for use in the manufacturer of...

1.1 This Standard addresses the following aspects of cementitious materials: (a) their definitions; (b) their chemical, physical, and uniformity requirements; (c) the tests required; (d) the procedures for inspection and...

1.1 This Standard addresses the following aspects of cementitious materials: (a) their definitions; (b) their chemical, physical, and uniformity requirements; (c) the tests required; (d) the procedures for inspection and...

Aligning the standard with other standards in this portfolio that were updated after Z1007 was published such as CSA Z107.6 and Z107.56. Redesigning the standard to remove guidance information and add it as new annexes and...

Note: This NOI was withdrawn by the responsible SDO on June 27, 2023. 1.1 This Standard specifies the requirements and test methods for bead-applied one component polyurethane foam used as an insulating air sealant for both...

This International Standard specifies requirements for an event sustainability management system for any type of event or event-related activity, and provides guidance on conforming to those requirements. This International...

This group safety publication is primarily intended to be used as a product safety standard for the products mentioned in the scope, but shall also be used by technical committees in the preparation of their publications for...

CAN/CSA-ISO 13857, Safety of machinery — Safety distances to prevent hazard zones being reached by upper and lower limbs is an adoption without modification of the identically titled ISO (International Organization for...

Based on the IEEE 1888™ protocols, this standard describes network gateway central access control and management policy through the extension of existing interface protocols, message formats, and interactive processing in...

1.1 This Standard applies to single-conductor and multiple-conductor cables for use in Fault Managed Power Systems (FMPS). These cables are intended to be installed in accordance with the Canadian Electrical Code, Part I. 1.2...