Search

1.1 This Standard applies to single-polarity, hand-, or tool-applied splicing wire and cable connectors intended for use with all alloys of copper, aluminum conductors, or copper-clad aluminum conductors, or all three, in...

Note: The standards development activity and project need for this NOI (originally published on February 8, 2022), was updated by the responsible SDO on August 3, 2022. The project need was updated on September 7, 2022. This...

1 Scope 1.1 These requirements cover metallic and nonmetallic safety cans that have a maximum capacity of 5.3 US gallons (20 L) and that are intended to store and handle flammable and combustible liquids in commercial and...

1 General Replace this clause of the RD with the following: 1.1.1 Equipment covered by this Standard This Standard applies to UNINTERRUPTIBLE POWER SYSTEMS (UPS). The primary function of the UPS for this Standard is to ensure...

1.1 This Standard covers the design and construction of aboveground steel non-pressure tanks intended for installation inside or outside buildings and for the storage of: A Combustible liquid intended to be used as heating...

1 General Replace this clause of the RD with the following: 1.1.1 Equipment covered by this Standard This Standard applies to UNINTERRUPTIBLE POWER SYSTEMS (UPS). The primary function of the UPS for this Standard is to ensure...

1.1 Inclusions 1.1.1 This International Standard specifies general requirements for the characterization of a sterilizing agent and for the development, validation and routine monitoring and control of a sterilization process...

2.1 Type of Equipment This Standard applies to fusion welded wrought steel enclosures pressurized with dry air, inert gases, eg, sulphur hexafluoride, carbon tetrafluoride, or nitrogen or a mixture of such gases, used in...

1.1 Application This Standard applies to single- and multi-section buildings supported on longitudinal floor beams, or perimeter rim joists designed to perform as beams. 1.2 Issues addressed This Standard specifies...

1.1 These requirements cover permanently installed devices, hereafter referred to as dimmers, that employ a dimming function intended for control of lighting loads of the magnetic ballast, transformer, electronic ballast...

1.1 These requirements and methods of test apply to fire damper assemblies rated ¾ h, 1 h, 1½ h, 2 h, or 3 h for use in air-conditioning and ventilating system ducts or openings (without ducts) piercing horizontally or...

1.1 This Standard applies to newly produced non-metallic dip tubes intended for use in water heaters. 1.2 Compliance of a dip tube with this Standard does not imply that such dip tube is acceptable for use in water heaters...