Search

1. The Standards for foam liquid concentrates are divided into three categories. Category 1 Primarily for use on general-purpose hydrocarbon fires Category 2 Primarily for use on polar solvents, oxygenated fuels, and water...

These requirements and methods of test apply to fire damper assemblies rated 3/4 h, 1 h, 1-1/2 h, 2 h, or 3 h for use in air-conditioning and ventilating system ducts or openings (without ducts) piercing horizontally or...

This Standard will become a NSC 1.1 Application This Standard applies to single- and multi-section buildings supported on longitudinal floor beams, or perimeter rim joists designed to perform as beams. 1.2 Issues addressed...

1.1 This Standard sets forth minimum requirements for primary carrier, secondary containment, integral primary/secondary , normal vent and vapour recovery , metallic , composite and nonmetallic pipe, fittings, and systems...

1 SCOPE 1.1 These requirements cover temporary lighting strings rated not more than 20 A, 125 V, intended for indoor and outdoor use to provide temporary illumination during the period of construction, remodeling, maintenance...

1.1 These requirements cover bare and covered ferrules intended for field wiring and factory wiring for use in accordance with the National Electrical Code, ANSI/NFPA-70 and Canadian Electrical Code, Part I, CSA C22.1. 1.2...

1 SCOPE 1.1 These requirements cover emergency breakaway fittings intended only for flammable and combustible liquid service including gasoline with up to 15 % ethanol. 1.2 An emergency breakaway fitting is intended for use...

Note: This NOI was withdrawn by the responsible SDO on February 14, 2023. Scope This International Standard specifies procedures and requirements for the identification and labelling of plastics, and products made from...

1.1 Application This Standard applies to single- and multi-section buildings supported on longitudinal floor beams, or perimeter rim joists designed to perform as beams. 1.2 Issues addressed This Standard specifies...

1.1 These requirements cover electrically operated single and multiple station smoke alarms intended for open area protection in indoor locations and portable smoke alarms used as "travel" alarms in accordance with: a)...

1 Scope 1.1 These requirements cover stationary engine generator assemblies that are intended for installation and use in ordinary locations in accordance with the following: a) The National Electrical Code, NFPA 70; b) The...

1.1 This Standard applies to single-polarity, hand-, or tool-applied splicing wire and cable connectors intended for use with all alloys of copper, aluminum conductors, or copper-clad aluminum conductors, or all three, in...