Search

1.1 This Standard specifies methods for measuring the volume, energy consumption, and total display area (TDA) of electrically operated commercial refrigeration equipment. 1.2 This Standard applies to commercial refrigerator...

Z241.0-03 - Definitions and General Safety Requirements for Park Model Trailers 1. Scope This Standard provides the definition of the term "park model trailer" as used in the CSA Z241 Series. It also gives general safety...

Z241.0 - Definitions and General Safety Requirements for Park Model Trailers 1. Scope This Standard provides the definition of the term "park model trailer" as used in the CSA Z241 Series. It also gives general safety...

This service template is compliant with the UPnP Device Architecture version 1.0 [14]. It defines a service type referred to herein as RenderingControl. 1.1 Introduction Most rendering devices contain a number of dynamically...

IEC 60601-1:2005+Amendment 1:2012, Clause 1 applies, except as follows: 201.1.1 Scope IEC 60601-1:2005+Amendment 1:2012, 1.1 is replaced by: This particular standard specifies requirements for the BASIC SAFETY and ESSENTIAL...

1.1 This Standard applies to fans and ventilation equipment that are a) cord-connected, rated at not more than 250 V; b) permanently connected to supply circuits of 600 V or less, single-phase or three-phase; c) used in non...

1.1 This Standard covers controlled outlets, equipped with or without locking or non-locking receptacle configurations, for permanently connected branch circuit installation, rated up to and including 600 V, 60A and intended...

This service template is compliant with the UPnP Device Architecture version 1.0 [14]. It defines a service type referred to herein as RenderingControl. 1.1 Introduction Most rendering devices contain a number of dynamically...

1.1 This Standard applies to a) electrostatic air cleaners intended to remove dust and dirt from the air and intended for general indoor residential and commercial use; b) air ionizer type air cleaners; c) other similar...

1 Scope 1.1 This standard sets forth minimum requirements for the following types of devices for engine fuel system applications intended for use with liquefied petroleum gas (LP-Gas), natural gas, and/or manufactured gas. a)...

Replacement: This part of IEC 61558 deals with the safety of shaver transformers, power supply units incorporating a shaver transformer, and shaver supply units. Shaver transformers incorporating electronic circuits are also...

1 Scope 1.1 Scope and references This standard details mechanical, physical, and electrical requirements for newly manufactured appliance that dispense natural gas for vehicles directly into the vehicle natural gas fuel...