Search

1.1 This Standard covers commercial and industrial plant oil extraction equipment for installation and use indoors in an ordinary (unclassified) locations and hazardous (classified) locations. Based on the application...

1.1 This Standard covers commercial and industrial plant oil extraction equipment for installation and use indoors in an ordinary (unclassified) locations and hazardous (classified) locations. Based on the application...

1.1 Scope Based on the protocol defined in IEEE Std 1888™1, IEEE Standard for Ubiquitous Green Community Control Network Protocol, this standard extends component and data type definitions, message formats, and communication...

This part of ISO/IEC 14165 describes extensions to the Fibre Channel signaling and physical layer requirements defined in ISO/IEC 14165-142, Fibre Channel - Physical Interfaces 2, to transport Fibre Channel over the commonly...

This part of IEC 60079 specifies the requirements for the design, construction, testing and marking of Ex Equipment and Ex Components with type of protection liquid immersion o intended for use in explosive gas atmospheres...

This part of IEC 60079 contains the specific requirements for design, construction and assessment of intrinsically safe systems, Type of Protection “i”, intended for use, as a whole or in part, in locations in which the use...

1.1 This Standard applies to newly produced gas-fired low-pressure steam and hot water boilers with gas inlet pressure ratings not exceeding 0.5 psi (3.5 kPa) and having input ratings of less than 12,500,000 Btu/hr (3 663 389...

This standard establishes the requirements for technical reviews and audits to be performed throughout the acquisition life cycle for the US Department of Defense (DoD) and other defense agencies. This standard provides the...

This part of ISO/IEC 14776 defines the command set extensions to facilitate operation of SCSI direct access block devices. The clauses in this standard, implemented in conjunction with the applicable clauses of SPC-4, specify...

This document describes the treatment of data centre metrics in circumstances where electrical energy is stored and exported from within the data centre boundaries of other standards in the ISO/IEC 30134 series. This document...

This document defines the crypto suite for SIMON for the ISO/IEC 18000 air interfaces standards for radio frequency identification (RFID) devices. Its purpose is to provide a common crypto suite for security for RFID devices...

Replacement: This particular standard specifies safety requirements for OPERATING TABLES, whether or not having electrical parts, including TRANSPORTERS, used for the transportation of the table top to or from the base or...