Search

1.1 This Standard describes the design, construction, load rating, installation, erection, inspection, maintenance, repair, modification, test, and operation of lattice and telescopic boom mobile cranes. Note: See Annex A for...

1.1 Purpose The purpose of this Standard is to provide minimum requirements for the design, construction, and marking of electrical equipment or parts of such equipment for use in Class I and Class II, Division 2 and Class...

This clause of Part 1 is applicable, except as follows. 1.1.1 Equipment included in scope Replacement: This part of IEC 61010 specifies safety requirements and related verification tests for control equipment of the following...

1.1 This Standard specifies general requirements related to the safety of human cells, tissues, and organs used for transplantation, and includes quality system requirements. It includes aspects of safety for potential and...

1.1 Introduction 1.1.1 The purpose of this standard is to provide minimum requirements for the design, construction, and marking of electrical equipment or parts of such equipment for use in Class I and Class II, Division 2...

1.1 This Standard describes methods for determining the occupational noise exposure level of workers (Lex,T) using sampling techniques. Lex,T represents the long-term noise exposure of workers and is calculated from...

Note: The designation number for this NOI (originally published on October 12, 2022) was updated by the responsible SDO on November 22, 2022. 1.1 This Standard applies to newly produced decorative gas appliances for outdoor...

1.1 Standard addresses This Standard is intended to address the safe, effective, and reliable reprocessing of reusable medical devices at each phase of the reprocessing workflow, including a) establishing a QMS for the MDRA...

The rapid growth of distributed processing has lead to a need for a coordinating framework for the standardization of Open Distributed Processing (ODP). This Reference Model of ODP provides such a framework. It creates an...

1.1 Applicable equipment This Standard applies to newly produced, outdoor cooking specialty gas appliances, hereinafter referred to as “appliances”, constructed entirely of new, unused parts and materials. Note: Appliances...

1.1 This Standard sets forth methods for both new installation and replacement installation of factory assembled windows, exterior doors, and skylights that are intended for installation in low-rise buildings and buildings...

CSA/ANSI 3.21:19, Part 1 - Industrial gas-fired natural draft heaters for installation in non-hazardous locations in oil and gas process applications Scope 1.1 CSA/ANSI 3.21, Industrial gas-fired natural draft heaters for...