Search

1.1 This Standard covers plumbing supply fittings and accessories located between the supply stop and the terminal fitting, inclusive, as follows: (a) automatic compensating valves for individual wall-mounted showering...

1.1 This Standard describes the test procedures, test set-ups, and calculations required to determine the performance, capacities, energy consumption, and overall efficiency of gas-fired and oil-fired combined space and water...

1.1 This Standard specifies requirements for adjustable speed drives with respect to electrical, thermal, and energy safety considerations. It applies to adjustable speed a.c. and d.c. electric drives connected to line...

1.1 This Standard covers plumbing supply fittings and accessories located between the supply stop and the terminal fitting, inclusive, as follows: (a) automatic compensating valves for individual wall-mounted showering...

1.1.1 This Code covers decentralized wastewater systems that use soil absorption systems for infiltration, dispersal, and final treatment of wastewater and serve residential, institutional, and commercial establishments. Note...

1.1 This Standard applies to the a) design; b) location; c) construction; d) operation; and e) maintenance of facilities for the liquefaction of natural gas and facilities for the storage, vaporization, transfer, handling...

1.1 This Standard specifies the requirements for single-phase, pad-mounted distribution transformers with separable insulated high-voltage connectors and intended primarily for operation by electric utilities. Note: The...

1.1 This Standard specifies the requirements for three-phase, pad-mounted distribution transformers, consisting of a transformer and a cable entrance compartment with provision for separable insulated high-voltage connectors...

.1 These requirements cover FITTINGS for use with cable and conduit intended for installation in accordance with the National Electrical Code, ANSI/NFPA 70, the Canadian Electrical Code (CEC), Part I, CSA C22.1, and the...

1. Scope This clause of Part 1 is replaced as follows: 1.1 This standard applies to automatic electrical pressure sensing controls with a minimum gauge pressure rating of -60 kPa and a maximum gauge pressure rating of 4,2 MPa...

1.1.1 This standard applies to newly produced automatic gas ignition systems (see Part III, Definitions) and components thereof other than types utilizing low, extra low, or high voltages, constructed entirely of new, unused...

This clause of Part 1 is replaced as follows: 1.1 This Part of International Standard IEC 730 applies to electrically operated door locks intended to prevent the opening of doors in equipment for household and similar use...