Search

1.1 This Standard provides a method for measuring annual fireplace efficiency. 1.2 This Standard applies to vented gas fireplaces meeting the requirements of ANSI Z21.50/CSA 2.22 and to vented gas fireplace heaters approved...

1.1 This Standard provides a method for measuring annual fireplace efficiency. 1.2 This Standard applies to vented gas fireplaces meeting the requirements of ANSI Z21.50/CSA 2.22 and to vented gas fireplace heaters approved...

1. Scope 1.1 This International Standard specifies the procedures to be followed for preparing, maintaining, and publishing a register of escape sequences and of the coded character sets they identify. 1.2 The registration...

1.1 This Standard describes test methods for characterization of base cellulose nanomaterials, specifically those designated as cellulose nanocrystals (CNCs), cellulose nanofibrils (CNFs) and cellulose microfibrils (CMFs)...

1.1 This Standard provides guidance and a blank detail specification for cellulose nanomaterials (CNMs), for determining and listing essential properties and characteristics with reference to corresponding test methods in CSA...

1.1 The requirements of this Standard apply to materials, constructions, and testing of tree-retardant cross- linked polyethylene and ethylene propylene rubber-insulated single conductor or triplexed primary shielded and...

1.1 This Standard covers asphalt core boards intended for use as a substrate to receive an asphalt-based, low-slope roofing membrane (built-up roofing or modified-bitumen). In such systems, the roofing membrane can be adhered...

This Standard specifies performance requirements for thermostat models intended for line-voltage (120 to 240 V) switching of a controlled resistive heating load. The models covered by this Standard are as follows: a) wall...

1.1 This Standard specifies requirements for the installation of electric storage tank and heat pump water heaters intended for use in residential premises. 1.2 This Standard applies to (a) electric storage tank water heaters...

Note: this standard is an adoption of the European Committee for Standardization (CEN) standard EN1434-3 . This European Standard specifies the general requirements for heat meters. Heat meters are instruments intended for...

1.1 This Standard applies to: (a) heater elements for use in equipment that is intended to be connected to a supply of nominal system voltage of 600 V or less; and (b) those heater 1.2 This Standard applies to the following...

1.1 This Standard applies to expandable sleeving rated at 90°C, 105°C, 125° C, 150°C and 200°C for bundling of insulated wires and cables, intended for the use in equipment designed to be installed and used in accordance with...