Search

1.1 This Standard specifies requirements for copper and aluminum conductor secondary and service- entrance cables intended for use on systems having a nominal voltage of 600 V or less in underground installation a) by direct...

Note: This notice of intent was withdrawn by the responsible SDO on February 6, 2024. 1.1 This Standard applies to electrically-powered door opening devices and other opening and closing appliances rated at 600 V or less and...

Scope 1.1 This Standard specifies the test methods and marking requirements, and references energy efficiency levels for three-phase induction motors. Note: The test methods contained in this Standard are not limited to...

This part of ISO/IEC 14776 defines the command set extensions to facilitate operation of SCSI direct access block devices. The clauses in this standard, implemented in conjunction with the applicable clauses of SPC-4, specify...

This standard provides dimensional and performance requirements for safety, durability and structural adequacy of free-standing components of office desk/table and storage products, including benching systems. Vertical filing...

This part of IEC 60079 is applicable to electrical equipment protected by enclosure and surface temperature limitation for use in explosive dust atmospheres. It specifies requirements for design, construction and testing of...

This part of IEC 61400 specifies additional requirements for assessment of the external conditions at an offshore wind turbine site and it specifies essential design requirements to ensure the engineering integrity of...

1.1 This Standard specifies a) energy performance requirements for factory-made, self-contained, electrically-operated, mechanically-refrigerated household dehumidifiers with daily water-removal capacities of up to 87.5 L...

1.1 This Standard applies to enclosed equipment that is to be permanently field connected to line or load circuits rated 1000 V or less in accordance with CSA C22.1, Canadian Electrical Code, Part I. 1.2 This Standard applies...

1.1 This Standard specifies the dimensional and material requirements for facially featured headforms to be used in the testing of full-face protection and eye protection equipment, especially impact protection testing. 1.2...

Z240.0.1 1.1 This Standard specifies general requirements for manufactured homes, including quality requirements and requirements on equivalency of performance, interior markings, and provision of printed instructions. 1.2 In...