Search

This project develops a set of common functionality for the family of IEEE 1451 smart transducer interface standards. This functionality is independent of the physical communications media. It includes the basic functions...

This Standard specifies the following for the other parts of ISO/IEC 30134: a) a common structure; b) definitions, terminology and boundary conditions for KPIs of data centre resource usage effectiveness and efficiency; c)...

1. Scope This part of ISO/IEC 14776 defines a Reduced Block Command set for logical block devices. The Reduced Block Commands, along with the required SPC-2 commands and their restrictions described in this standard, fully...

This part of IEC 61936 provides common rules for the design and the erection of electrical power installations in systems with nominal voltages above 1 kV a.c. and nominal frequency up to and including 60 Hz, so as to provide...

1. Scope This standard defines the mechanical, electrical, timing, and protocol requirements of the SCSI parallel interface to allow conforming SCSI devices to inter-operate. The SCSI parallel interface is a local I/O bus...

(The New Edition is currrently being worked on.) Scope This clause of part 1 is replaced by: This standard deals with the safety of electric commercial kitchen machines not intended for household use, their rated voltage...

Scope This clause of part 1 is replaced by: This standard deals with the safety of electric commercial kitchen machines not intended for household use, their rated voltage being not more than 250 V for single phase appliances...

This part of ISO/IEC 15426 defines test methods and minimum accuracy criteria for verifiers using the methodology of ISO/IEC 15416 for linear bar code symbols, and specifies reference calibration standards against which these...

Update 4 to CAN/CSA C22.2 No. 61010-1-12 ED 3+ AMD.1 2018, Safety Requirements for Electrical Equipment for Measurement, Control, and Laboratory Use - Part 1: General, as a revised IEC-based CSA Standard.

This Standard applies to transportable drills, with manually fed axial movement of the spindle, having a maximum chuck capacity of 13 mm. The rated voltage is not more than 250 V for single-phase a.c. or d.c. tools, and 480 V...

This clause of Part 1 is applicable, except as follows: Addition: This part of IEC 62841 applies to transportable mitre saws intended to be used with a toothed saw blade for cutting wood and analogous materials, plastics and...

This part of IEC 61000 relates to the immunity requirements, test methods, and range of recommended test levels for equipment to unidirectional surges caused by overvoltages from switching and lightning transients. Several...