Search

Aligning the standard with other standards in this portfolio that were updated after Z1007 was published such as CSA Z107.6 and Z107.56. Redesigning the standard to remove guidance information and add it as new annexes and...

1.1 This Standard addresses the following aspects of cementitious materials: (a) their definitions; (b) their chemical, physical, and uniformity requirements; (c) the tests required; (d) the procedures for inspection and...

This Standard defines the following: - dimensions of a Biometric System-on-Card type S1 and type S2; - position and size of the biometric capture device; - minimum requirements to a Biometric System-on-Card with respect to -...

This part of ISO/TR 19566 describes common elements of a system layer for JPEG standards, referred to as JPEG Systems. This part of ISO/TR 19566 describes the common architecture of file formats and codestream formats used in...

1.1 This Standard applies to isolating switches, without enclosures, for use indoors at voltages from 751 to 46 000 V ac or for installation in switchgear assemblies (see CSA Standard C22.2 No. 31) or similar equipment for...

1.1 This Standard specifies material and fabrication requirements for corrugated steel pipe, spiral rib pipe, structural plate corrugated steel pipe products, and two-flange tunnel liner plate. 1.2 This Standard applies to...

This clause of Part 1 is applicable, except as follows: Addition: This part of IEC 62841 applies to transportable drain cleaners. NOTE 101 Drain cleaners are also known as pipe cleaners. This standard does not apply to hand...

The Standard applies to the basic safety and essential performance of X-ray based image-guided radiotherapy (IGRT) equipment for use with External Beam Equipment (EBE). This particular standard covers safety aspects of...

1.1 This Standard specifies the requirements for single-phase, pad-mounted distribution transformers with separable insulated high-voltage connectors and intended primarily for operation by electric utilities. Note: The...

1.1 General This Standard applies to structural antennas, towers, antenna-supporting structures, and roof- and wall- mounted structures, including their components, such as guys and foundations. It covers the structural...

These requirements will provide modifications to the ANSI/CAN/UL 12402-9 standard.

This group safety publication is primarily intended to be used as a product safety standard for the products mentioned in the scope, but shall also be used by technical committees in the preparation of their publications for...