Search

This Standard specifies requirements and test methods only for hoists and body-support units intended for the transfer of disabled persons as classified in ISO 9999:2002: ⎯ 12 36 03 Mobile hoists with sling seats ⎯ 12 36 04...

Devices covered by this standard are pilot operated, diaphragm types. Devices shall be permitted to have a strainer connected to the valve inlet or be without strainer.

This standard establishes the requirements for systems engineering activities to be performed on projects of the United States (US) Department of Defense (DoD) and other defense agencies across the entire system life cycle...

This document addresses the wide range of telecommunications cabling infrastructures within data centres based upon the criteria and classifications for availability within ISO/IEC TS 22237-1. This document specifies...

(The New Edition is currrently being worked on.) Scope This clause of part 1 is replaced by: This standard deals with the safety of electric storage water heaters for household and similar purposes and intended for heating...

This part of IEC 61869 applies to newly-manufactured combined transformers for use with electrical measuring instruments and electrical protective devices at frequencies from 15 Hz to 100 Hz. The requirements and tests of...

This clause of Part 1 is applicable, except as follows: Addition: This part of IEC 62841 applies to hand-held circular saws, which hereinafter will be referred to as saws. This standard does not apply to saws designed for use...

This document sets the general and dimensional interchangeability requirements for plugs, socket-outlets, connectors and appliance inlets with arcuate contacts of standardized configurations (hereinafter referred to as...

This Standard specifies the message structure, sequences and protocol of the application layer for use in network enhanced control devices of the Home Electronic System (HES) Class 1. It provides the services and the...

This service definition is compliant with the UPnP Device Architecture version 1.0 and Version 1.01 of the UPnP Standard Service Template. This service-type enables the following functions: · basic power switching for...

This clause of Part 1 is applicable, except as follows: Addition: This part of IEC 62841 applies to hand-held circular saws, which hereinafter will be referred to as saws. This standard does not apply to saws designed for use...

This part of ISO/IEC 15426 defines test methods and minimum accuracy criteria applicable to verifiers using the methodologies of ISO/IEC 15415 for multi-row bar code symbols and two-dimensional matrix symbologies, and...