Search

This standard outlines the requirements for a site quality assurance program (SQAP) for the on-site installation of spray applied polyurethane foam (SPF). As the installation of the material is dependent on the installer, a...

1.1 These minimum requirements cover regulators used to reduce the pressure of compressed industrial gases from a source or storage cylinder pressure of not more than 5500 psig (37.91 MPa) to the use pressure. 1.2 Regulators...

These requirements cover the construction and performance, exclusive of performance during fire tests, of portable water based agent fire extinguishers. These fire extinguishers are intended to be utilized in accordance with...

1.1 This Standard specifies the requirements for installation of mineral fibre thermal insulation products for buildings such that, when installed, a product manufactured and packaged according to CAN/ULC-S702 will provide...

This clause of Part 1 is applicable except as follows: 1.1.1 Equipment included in scope Replacement: This part of IEC 61010 specifies safety requirements for electrically powered laboratory equipment for the heating of...

201.1 Scope, object and related standards Clause 1 of the general standard2) applies, except as follows: 201.1.1 * Scope Replacement: This International Standard applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of...

201.1 Scope and object Clause 1 of the general standard1) applies, except as follows: 201.1.1 Scope Replacement: This International Standard applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of DENTAL UNITS, DENTAL...

Note: The ICS code for this NOI wasupdated by the responsible SDO on April 23, 2024. HSO has decided to convene a standards Technical Committee to revise the current safety intervention standard for Antimicrobial Stewardship...

Note: The standard designation number for this NOI (originally published on July 16, 2019), was updated by the responsible SDO on July 13, 2021. Note: The title and scope for this NOI (originally published July 16, 2019) was...

1.1 This Standard outlines requirements for the installation of spray applied rigid polyurethane foam, medium density. The material can be installed as thermal insulation, air barrier, vapour barrier or any combination of...

1.1 This standard sets out criteria for specification of air barrier assemblies that may be used in design specification documents or in manufacturer’s product literature. 1.2 This standard provides the requirements and test...

This document provides specific requirements for process sealing between a flammable process fluid and an electrical system where a failure could allow the migration of the process fluid directly into the premises wiring...