Refine Results
Displaying 9781 - 9792 of 11672
Safety code for elevators and escalators
1.1.1 Equipment Covered by This Code This Code covers the design, construction, operation, inspection, testing, maintenance, alteration, and repair of the following equipment and its associated parts, rooms, spaces, and...
Standard for Multioutlet Assemblies
Note: NOI for UL 111 was withdrawn on 2018-06-19 as requested by the responsible SDO. Note: Scope updated 2018-03-20 as per a request from the responsible SDO. 1.1 These requirements cover Multioutlet Assemblies and factory...
Explosive atmospheres - Part 29-1: Gas detectors - Performance requirements of detectors for flammable gases (Adopted IEC 60079-29-1:2007, first edition, 2007-08, with Canadian deviations)
This part of IEC 60079-29 specifies general requirements for construction, testing and performance, and describes the test methods that apply to portable, transportable and fixed apparatus for the detection and measurement of...
Automatic electrical controls for household and similar use - Part 1: General requirements
1 Scope 1.1 In general, this International Standard applies to automatic electrical controls for use in, on, or in association with equipment for household and similar use, including controls for heating, air-conditioning and...
Information technology — Radio frequency identification for item management — Part 6: Parameters for air interface communications at 860 MHz to 960 MHz General
Scope This part of ISO/IEC 18000 defines the air interface for radio frequency identification (RFID) devices operating in the 860 MHz to 960 MHz Industrial, Scientific, and Medical (ISM) band used in item management...
Notice of Intent
Accessible design for the built environment
1.1 Purpose This Standard specifies technical requirements on how to make buildings and the exterior built environment accessible and safely usable by persons with physical, sensory, or cognitive disabilities. Commentary: (1)...
Notice of Intent
Safety of Household and Similar Electrical Appliances...
This clause of Part 1 is replaced by the following. This International Standard deals with the safety of electric HEAT PUMPS, including SANITARY HOT WATER HEAT PUMPS, AIR-CONDITIONERS, and DEHUMIDIFIERS incorporating motor...
Notice of Intent
Mechanical Couplings for Drain, Waste, and Vent...
1.1 This Standard covers mechanical couplings that are used to axially join pipes and fittings in non-pressure drain, waste, and vent (DWV) piping systems and sewer piping systems located inside or outside buildings and above...
Notice of Intent
Use of electricity in mines
1.1 Purpose This Standard establishes minimum requirements for electrical work and electrical equipment operating, or intended to operate, in mines. Note: Users should be aware that federal, provincial, and territorial...
Notice of Intent
Single pole locking-type separable connectors
1.1 These requirements cover single pole locking-type separable attachment plugs, cord connectors, panel inlets, and panel outlets, adapters, and accessories, rated up to a maximum of 800 amperes and up to 600 volts ac or dc...
Notice of Intent
Gas water heaters, volume I, storage water heaters...
1.1 This Standard applies to newly produced, automatic storage water heaters having input ratings of 75,000 Btu/hr (21 980 W) or less (see Clause 3, Definitions), hereinafter referred to as water heaters or appliances...
Notice of Intent
Gas-fired low pressure steam and hot water boilers
1.1 This Standard applies to newly produced gas-fired low-pressure steam and hot water boilers with gas inlet pressure ratings not exceeding 0.5 psi (3.5 kPa) and having input ratings of less than 12,500,000 Btu/hr (3 663 389...